What it means
The H2O light is the water filter reminder on a French-door JennAir refrigerator. Change the filter about twice a year, or when the light comes on, then reset the status by holding LIGHT and ICE TYPE for three seconds.
JennAir refrigerator H2O light / Filters
The H2O light is the water filter reminder on a French-door JennAir refrigerator. Change the filter about twice a year, or when the light comes on, then reset the status by holding LIGHT and ICE TYPE for three seconds.
Also shown as H2O light
The H2O light is the water filter reminder on a French-door JennAir refrigerator. Change the filter about twice a year, or when the light comes on, then reset the status by holding LIGHT and ICE TYPE for three seconds.
Fit a new JennAir water filter first.
The light is still lit after a new filter and a reset.
Checks you have ticked / saved in this browser

Fit a new JennAir water filter first. Usage and water quality may call for more frequent changes.

This resets the status after changing the filter. The status light turns off when the system resets.

A clogged or badly seated filter may weaken the ice and water supply.

The reset varies; see the page that covers your control panel.
Send the model and the checks you have already run, then begin your request from this page.
Book a visitA simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
JennAir recommends replacing the refrigerator water filter every 6 months, when the indicator light comes on, or as needed.
Read the definitionJennAir recommends changing at 6 months, when the light appears, or earlier if needed.
Read the supporting manualAccording to the page, such a filter cuts the water reaching the ice maker and dispenser, which can mean less ice and a slower pour.
Read the supporting manualThe page recommends everydrop water filters. We do not sell filters.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2026-01-27; PH 14188 / PH 14188 (French-door refrigerator)
Applies to JennAir French-door refrigerators. Source: product page PH 14188, last modified 2026-01-27.
After changing the filter, press and hold the LIGHT and ICE TYPE buttons for 3 seconds. The status light turns off when the system resets.
The page says a clogged or improperly installed filter can reduce water flow to the ice maker and dispenser, causing low ice production and slower water flow.
No. JennAir's guidance is six months, the light or sooner when needed. Heavy use or poor water quality may call for sooner.
The Water filter status light will not reset page lists three reset methods by control type. Try the one that matches your panel.
The page recommends everydrop water filters. We do not sell filters, so use the number printed in your manual.
Code or symptom, part, service call
The water filter status does not reset automatically when you change the filter. On a French-door JennAir the reset depends on the control: Type 1 touches MAX COOL and MAX ICE for three seconds, Type 2 holds FILTER RESET, Type 3 holds WATER FILTER for three seconds.
On a JennAir the interior lights turn themselves off after the door has been open 10 minutes. Close every door for 1 minute to reset. Then check the door switch, the wiring plug after a delivery, Sabbath mode and the bulb.
JennAir recommends replacing the refrigerator water filter every 6 months, when the indicator light comes on, or as needed. A clogged or badly seated filter can slow water flow, thin the ice or stop ice. After changing it, you must reset the status light on most models.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.