FL / Our office
Tampa Bay
100 N Tampa St, Ste 140Tampa, FL 33602
Find your service area
Locate your metro, say how we reach the appliance, and we will confirm the visit.

Our offices
Choose a map marker or scan the address list. The offices are our bases; appliance service happens at your home.
FL / Our office
FL / Our office
FL / Our office
NY / Our office
TX / Our office
IL / Our office
CA / Our office
CA / Our office
CA / Our office
What happens on a visit.
No surprises in your kitchen.

Tell us which appliance, what the display shows and where it is installed. A photo of the model plate helps.

The technician inspects the unit, explains the likely cause and agrees the cost with you before starting.

When the work is done, the technician tests the appliance and walks you through what was fixed.
Bayfront buildings often reserve a service elevator. Book it early if the unit is a heavy wall oven.
Visitor checkpoints can hold a technician for several minutes. Update the guest list ahead of time.
Collins Avenue and Brickell buildings may funnel contractors through one door. Allow time to sign in.












Before any work begins, the technician tells you what is needed and settles the cost with you. A built-in appliance may need to be examined on site before that figure is firm.
If JennAir's manufacturer warranty covers the repair, JennAir itself does the work. We back our own workmanship with a warranty.
Nine metros: three in Florida (Tampa Bay, Orlando, South Florida), then New York, Houston, Chicagoland, and California's Los Angeles, San Diego and Bay Area.
Not by that alone. The office address shows where our staff sit, not our boundary. Send the appliance's address and we confirm if it is reachable.
Gates, stairs, parking and freight lifts shape how a technician reaches a built-in unit. Each metro page names the local points to raise.
At any hour, as the form never shuts. Phones and visits run until 8 pm, and our reply follows with the details.
Code or symptom, part, service call
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.