Start from the symptom
JennAir hood vent hood lights not working.
Check three things: the control settings, the bulbs, and a power reset. JennAir says that if the vent hood fan operates, the lights should operate, so a working fan with dead lights points to the bulbs or the light circuit.

Start with safe observations.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Check the controls
Refer to the owner's manual for the correct light and fan settings.
- 2
Replace the bulbs
Replace the bulb or bulbs following the owner's manual. Let a hot bulb cool first.
- 3
Reset the power
Switch the circuit breaker off for a minute, back on, and verify the light operates.
- 4
Compare with the fan
If the fan runs, the lights should work too. If neither works, check the power supply.
More about this symptom.
What does JennAir say to check?#
The control settings, the bulbs and a power reset. It adds that the lights should work whenever the fan does.
What does the power reset involve?#
Breaker off for one minute, breaker on, then verify the light operates. It takes a couple of minutes and clears control glitches.
When has troubleshooting gone far enough?#
When new bulbs and a reset change nothing, or the lights fail along with the fan. That points to wiring or the control.
Systems a technician may investigate.
The symptom connects to these parts. What you observed cannot show that any single one has failed.
If the display adds a code.
Keep the exact message.
Code meanings for this appliance are not researched here. Rely on its model manual and attach a photo of the display to your request.
See the research statusWhen observation becomes a service request.
Leave internal testing to a technician.
New bulbs do not light after a reset.
The fan runs and the lights stay out.
Neither fan nor lights work and the breaker is on.
The bulb pops or flickers repeatedly.
Arrange a diagnosticSources and model boundaries.
The JennAir vent hood lights not working guidance rests on these references. Pick the manual that fits your model.
- Vent Hood Lights not Operating - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
Why do my JennAir hood lights not come on?
The listed checks are the control settings, the bulbs and the power. JennAir says if the fan operates, the lights should operate, so start with the bulbs.
How do I reset the power on the hood?
Turn the circuit breaker off for one minute, turn it back on, then check the light. JennAir gives this as the reset for hood lights.
Where do I find the right bulb?
In the owner's manual, which gives bulb information. JennAir sells replacement parts, but keep to the bulb type listed for your model.
May I change the bulb myself?
Follow the owner's manual and let the bulb cool. If the socket looks burned or the bulb keeps failing, stop and book a technician.
What if the fan works and the lights do not?
Replace the bulbs first. If new bulbs do not help after a reset, the light circuit or socket needs diagnosis by a technician.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir hood leaving cooking smoke in the kitchen
JennAir lists five checks: controls, a clean grease filter, a recirculating charcoal filter that is clogged, air movement in the room, and the vent installation. Turn the hood on first and keep it running for a few minutes once you finish.
Hood light bulbs
The hood lights are controlled with the fan controls. JennAir says if the hood fan works, the lights should too. The checks are the control setting, replacing the bulbs and resetting power at the breaker for one minute.
Hood repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.
