Inside the appliance
Hood light bulbs. In plain English.
The hood lights are controlled with the fan controls. JennAir says if the hood fan works, the lights should too. The checks are the control setting, replacing the bulbs and resetting power at the breaker for one minute.

Where it fits.
Hood light bulbs in the appliance
The page points to the owner’s manual for bulb access and gives no position.
The picture shows the kind of component only. It cannot tell you which replacement suits your model.
What you notice when this system needs a look.
A Hood light bulbs concern may show up with a drop in performance or a code that keeps returning. Testing comes first, before anyone decides the component is to blame.

JennAir hood leaving cooking smoke in the kitchen
JennAir lists five checks: controls, a clean grease filter, a recirculating charcoal filter that is clogged, air movement in the room, and the vent installation. Turn the hood on first and keep it running for a few minutes once you finish.

JennAir vent hood lights not working
Check three things: the control settings, the bulbs, and a power reset. JennAir says that if the vent hood fan operates, the lights should operate, so a working fan with dead lights points to the bulbs or the light circuit.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Check the controls
Make sure the light control is set. Your manual shows how for your hood.
- 2
Replace the bulbs
The page asks if you have replaced them. Your manual gives the steps.
- 3
Reset the power
Cut power at the breaker for a minute, restore it, then check the light.
- 4
Note the fan
If the fan works but the light does not, say so when you book.
Cleaning or replacement?
Leave internal testing to a technician.
Book us if new bulbs and a reset do not bring the lights back.
Arrange a diagnosticSources and model boundaries.
The Hood light bulbs guidance rests on these references. Pick the manual that fits your model.
- Vent Hood Lights not Operating - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
Why are my hood lights out?
Controls, burned-out bulbs or a power glitch. JennAir lists all three.
Should lights work if the fan does?
Yes, per JennAir.
How do I reset power?
Leave the circuit breaker off for a minute, then switch it back on.
Where do I find bulb steps?
In the owner’s manual for your hood.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir hood leaving cooking smoke in the kitchen
JennAir lists five checks: controls, a clean grease filter, a recirculating charcoal filter that is clogged, air movement in the room, and the vent installation. Turn the hood on first and keep it running for a few minutes once you finish.
Hood repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.

