What it means
A blinking Call for Service light on a built-in JennAir refrigerator calls for a power reset. Breaker off for five minutes, breaker on, then a couple of minutes of observation. If the light returns, schedule service.
JennAir refrigerator Call for Service / Alerts
A blinking Call for Service light on a built-in JennAir refrigerator calls for a power reset. Breaker off for five minutes, breaker on, then a couple of minutes of observation. If the light returns, schedule service.
Also shown as Call for Service
A blinking Call for Service light on a built-in JennAir refrigerator calls for a power reset. Breaker off for five minutes, breaker on, then a couple of minutes of observation. If the light returns, schedule service.
Keep the doors shut during the reset so the cold stays in.
The light returns after five minutes off.
Checks you have ticked / saved in this browser

Keep the doors shut during the reset so the cold stays in.

Find the breaker for the refrigerator's circuit. Time five full minutes.

Restore power and let the refrigerator start up.

Watch the panel to see whether the light returns, and verify the refrigerator is operating.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
JennAir's built-in refrigerator page lists it as a light that blinks or flashes and asks you to try resetting the power to the unit. It gives no part or cause.
Read the supporting manualThe page specifies a five-minute pause with the circuit off. That is longer than the one-minute wait used for the flashing F code, so follow the right page for your light.
Read the supporting manualIt means the reset was not enough. Book a technician rather than repeating resets.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2021-04-27; PH 9897 / PH 9897 (built-in refrigerator)
Applies to JennAir built-in refrigerators. Source: product page PH 9897, last modified 2021-04-27.
No. Call for Service has its own page with a five-minute breaker reset, while a flashing F uses a one-minute reset and an extra check that cooling is on.
The reset steps end with watching the refrigerator to make sure the code does not display again, and then verifying that it operates normally.
The page does not say. If the light persists and the refrigerator feels warm, move perishables elsewhere and book a visit.
The page does not say. After power returns, check the temperature set points on the display.
How the light behaved, whether the reset changed it, your model and any recent power events.
Code or symptom, part, service call
A flashing F on a built-in JennAir refrigerator display calls for a power reset: breaker off or unplug for one minute, restore power, make sure cooling is on, and watch for a minute. If the F keeps flashing, schedule service.
On a JennAir the interior lights turn themselves off after the door has been open 10 minutes. Close every door for 1 minute to reset. Then check the door switch, the wiring plug after a delivery, Sabbath mode and the bulb.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.