What it means
A flashing F on a built-in JennAir refrigerator display calls for a power reset: breaker off or unplug for one minute, restore power, make sure cooling is on, and watch for a minute. If the F keeps flashing, schedule service.
JennAir refrigerator Flashing F / Alerts
A flashing F on a built-in JennAir refrigerator display calls for a power reset: breaker off or unplug for one minute, restore power, make sure cooling is on, and watch for a minute. If the F keeps flashing, schedule service.
Also shown as Flashing F
A flashing F on a built-in JennAir refrigerator display calls for a power reset: breaker off or unplug for one minute, restore power, make sure cooling is on, and watch for a minute. If the F keeps flashing, schedule service.
Remove power for one full minute.
F keeps flashing after the reset.
Checks you have ticked / saved in this browser

Remove power for one full minute. Keep doors closed.

Turn the breaker on or plug the refrigerator back in.

After the reset, JennAir wants cooling confirmed as on.

See whether the flashing F returns.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
JennAir prints no meaning. JennAir classes it as an error code and asks for a reset. No part is named.
Read the supporting manualCall for Service uses a five-minute breaker reset. The flashing F uses one minute, and the page adds an instruction to check that cooling is on.
Read the supporting manualIts closing advice is to schedule service.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2021-04-27; PH 9901 / PH 9901 (built-in refrigerator)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-04-25; PH 1229 / PH 1229 (French-door refrigerator)
Applies to JennAir built-in refrigerators. Sources: PH 9901 (2021-04-27) and the general refrigerator page PH 1229 (2024-04-25).
No. It is filed as an error code with only a reset offered, and we invent no cause for it.
The reset steps end with ensuring the cooling function is turned on, since a refrigerator left in COOLING OFF will not cool.
Yes. The page says to turn off the circuit breaker or unplug the product for one minute, and then turn it on or plug it back in.
One minute, to see whether the error code displays again.
JennAir says to schedule service if the problem persists. Mention that you tried the one-minute reset.
Code or symptom, part, service call
A blinking Call for Service light on a built-in JennAir refrigerator calls for a power reset. Breaker off for five minutes, breaker on, then a couple of minutes of observation. If the light returns, schedule service.
On a JennAir the interior lights turn themselves off after the door has been open 10 minutes. Close every door for 1 minute to reset. Then check the door switch, the wiring plug after a delivery, Sabbath mode and the bulb.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.