What it means
If the control panel of a built-in JennAir refrigerator will not respond, JennAir asks you to rule out a recent power outage, Showroom or demo mode, and Sabbath mode before resetting the refrigerator. Check those three first.
JennAir refrigerator Control panel or interface not working / Controls
If the control panel of a built-in JennAir refrigerator will not respond, JennAir asks you to rule out a recent power outage, Showroom or demo mode, and Sabbath mode before resetting the refrigerator. Check those three first.
Also shown as Control panel or interface not working
If the control panel of a built-in JennAir refrigerator will not respond, JennAir asks you to rule out a recent power outage, Showroom or demo mode, and Sabbath mode before resetting the refrigerator. Check those three first.
If power went out recently, PO may flash and the red Power Outage icon shows.
The panel is still unresponsive after the modes are ruled out and power is reset.
Checks you have ticked / saved in this browser

If power went out recently, PO may flash and the red Power Outage icon shows. Other controls stay disabled until you confirm.

Some models have a mode for retail display that ignores most commands. The word Showroom may light up on the display.

In Sabbath mode, lights, alarms and dispenser pads are disabled while temperature set points stay unchanged.

If none of those apply, reset the power as the page's final step describes.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
The power outage indicator disables other control and dispenser functions until you confirm you know about the outage. PO flashes on the display.
Read the supporting manualOn some models it turns cooling off and deactivates every function except interior lighting, so the panel ignores most commands. The exit sequence varies by model; see your manual.
Read the supporting manualNo. It is a setting for religious observance. The exit sequence varies by model, per the page.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-09-05; PH 9898 / PH 9898 (built-in refrigerator)
Applies to JennAir built-in refrigerators. Source: product page PH 9898, last modified 2025-09-05.
After an outage PO flashes, and the controls and dispenser stay disabled until you confirm you know about it. Confirm it from the panel first.
On some models the display lights the word Showroom, and most commands are ignored. The exit sequence varies by model, so use your owner's manual.
Per the page, interior and dispenser lights, sounds and alarms, the dispenser backlight and the dispenser pads. Temperature set points stay unchanged.
Not necessarily. In several of these modes cooling continues. Once the panel responds, check the temperature; if it never does, book a visit.
Reset the refrigerator's power. If the panel is still dead after the modes are ruled out and the reset is done, book a technician.
Code or symptom, part, service call
On a JennAir the interior lights turn themselves off after the door has been open 10 minutes. Close every door for 1 minute to reset. Then check the door switch, the wiring plug after a delivery, Sabbath mode and the bulb.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.