What it means
COOLING OFF on a French-door JennAir refrigerator means cooling has been turned off, so neither the refrigerator nor the freezer cools. A common method to turn it back on is pressing LOCK and MEASURED FILL together for three seconds.
JennAir refrigerator Cooling Off / Controls
COOLING OFF on a French-door JennAir refrigerator means cooling has been turned off, so neither the refrigerator nor the freezer cools. A common method to turn it back on is pressing LOCK and MEASURED FILL together for three seconds.
Also shown as Cooling Off
COOLING OFF on a French-door JennAir refrigerator means cooling has been turned off, so neither the refrigerator nor the freezer cools. A common method to turn it back on is pressing LOCK and MEASURED FILL together for three seconds.
COOLING OFF appears on the display screen when cooling is off.
The refrigerator will not cool after you turn cooling on.
Checks you have ticked / saved in this browser

COOLING OFF appears on the display screen when cooling is off. Confirm it is that message.

Hold LOCK and MEASURED FILL together for three seconds. JennAir stresses pressing both together so the dispenser is not locked by accident.

COOLING OFF should disappear when cooling resumes.

Give the refrigerator time and verify temperatures before relying on it.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
The page names routine cleaning, a power outage or a surge as situations where a refrigerator may be turned off by accident or need turning back on.
Read the supporting manualNo. JennAir says the method varies by model and refrigerator type, and that the given one is common. Check your owner's manual.
Read the supporting manualCheck that the unit is turned on. The page says some refrigerators need to be manually turned back on after an outage or surge.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2026-01-27; PH 14186 / PH 14186 (French-door refrigerator)
Applies to JennAir French-door refrigerators. Source: product page PH 14186, last modified 2026-01-27.
Yes. The page names routine cleaning and power outages or surges as common causes. Some refrigerators need to be turned back on by hand after an outage.
JennAir warns that pressing LOCK and MEASURED FILL out of step can lock the dispenser or change other settings instead.
No. The page calls its button press a common method and says the steps vary by model and refrigerator type. Check your owner's manual.
The page gives no time. Watch the temperature display over the next few hours; if cooling is on but food stays warm, book a visit.
Both compartments stop cooling while the setting is off, so turn it back on soon and check frozen food.
Code or symptom, part, service call
On a JennAir the interior lights turn themselves off after the door has been open 10 minutes. Close every door for 1 minute to reset. Then check the door switch, the wiring plug after a delivery, Sabbath mode and the bulb.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.