What it means
PO means power to the refrigerator was off long enough for the freezer to reach 18 degrees F (-8 C) or higher. The display reads PO, a tone sounds three times, and Confirm blinks until you press MEASURED FILL under it.
JennAir refrigerator PO / Alerts
PO means power to the refrigerator was off long enough for the freezer to reach 18 degrees F (-8 C) or higher. The display reads PO, a tone sounds three times, and Confirm blinks until you press MEASURED FILL under it.
Also shown as PO
PO means power to the refrigerator was off long enough for the freezer to reach 18 degrees F (-8 C) or higher. The display reads PO, a tone sounds three times, and Confirm blinks until you press MEASURED FILL under it.
Judge freezer food against the 18 degrees F (-8 C) threshold the page names.
PO appears without a power cut.
Checks you have ticked / saved in this browser

Judge freezer food against the 18 degrees F (-8 C) threshold the page names. If food has thawed, use your own food-safety judgment.

This acknowledges the outage. PO clears and the Home screen comes back.

All other control and dispenser functions are disabled until the outage is confirmed.

Give the refrigerator time to cool and verify that it holds temperature.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
Power Outage. The indicator tells you the supply was off and the freezer temperature rose to 18 degrees F (-8 C) or higher.
Read the supporting manualThe page says all other control and dispenser functions are disabled until you confirm you are aware of the outage.
Read the supporting manualNo. It reports an event. If PO appears without any outage, check your power supply and book a visit.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2021-04-27; PH 9903 / PH 9903 (built-in refrigerator)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2026-01-27; PH 14185 / PH 14185 (French-door refrigerator)
Applies to JennAir built-in and French-door refrigerators. Sources: PH 9903 and PH 14185.
It sounds three times when the panel shows PO to tell you power was off long enough for the freezer to reach 18 degrees F (-8 C) or higher.
Press MEASURED FILL under the blinking Confirm. PO goes away and you are back at the Home screen.
Until you confirm the outage, the page says the other controls and the dispenser remain disabled.
JennAir gives only the temperature. Judge frozen food against that figure and use your own food-safety judgment for anything that thawed.
No. It reports an event. If PO appears with no outage, book a technician.
Code or symptom, part, service call
The temperature alarm sounds when the refrigerator rises above 48 degrees F (9 C) or the freezer above 15 degrees F (-9 C) for longer than 1.5 hours. The sound stops by itself; the light flashes until you press the alarm key. Column models call it Over-Temp.
On a JennAir the interior lights turn themselves off after the door has been open 10 minutes. Close every door for 1 minute to reset. Then check the door switch, the wiring plug after a delivery, Sabbath mode and the bulb.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.