Inside the appliance
Beverage center low temperature alert. In plain English.
CL or LO on a JennAir beverage center means the internal temperature is too low. JennAir’s checks are the door, a recent restock with warm items and a power outage. Then it asks for a one-minute power cycle.

Where it fits.
Beverage center low temperature alert in the appliance
The code shows on the beverage center control. The pages do not locate parts.
The picture shows the kind of component only. It cannot tell you which replacement suits your model.
What you notice when this system needs a look.
A Beverage center low temperature alert concern may show up with a drop in performance or a code that keeps returning. Testing comes first, before anyone decides the component is to blame.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Check the door
Make sure the door is fully closed and has not been open for a long time.
- 2
Think about restocking
A large load of warm or room-temperature drinks can change the temperature. Let it settle.
- 3
Think about outages
After a power outage, allow time for the temperature to stabilize.
- 4
Cycle power
Turn off the breaker or unplug the unit for one minute, restore power and watch for a minute to see if the code returns.
Cleaning or replacement?
Leave internal testing to a technician.
Book us if CL, LO, HI, E1 or E2 returns after the power cycle.
Arrange a diagnosticSources and model boundaries.
The Beverage center low temperature alert guidance rests on these references. Pick the manual that fits your model.
- CL or LO Error Code - Beverage Center - Product Help | JennAir
- HI or LO Error Code - Beverage Center - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
What does CL or LO mean?
The internal temperature is too low.
Can restocking cause it?
JennAir lists adding a large load of warm or room-temperature items as a possible cause.
How long should I wait after a power cut?
JennAir says to allow time for the temperature to stabilize, without giving a number.
How do I reset the code?
Cut power for one minute at the breaker or plug, restore it, and monitor for a minute.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir beverage center CL or LO and error displays
CL or LO means the internal temperature is too low. JennAir asks three questions: is the door fully closed, was it restocked with a large warm load, and was there a power outage. Then power down for one minute and back up. HI, LO, E1 and E2 get the same restart.
Beverage center repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.

