Before work starts
Before any work begins, the technician tells you what is needed and settles the cost with you. A built-in appliance may need to be examined on site before that figure is firm.
Independent appliance repair
We repair JennAir undercounter beverage centers that show CL, LO, HI, E1 or E2, run warm, run too cold or leak. Share the code and the moment it first appeared, then book a technician.

No further researched dishwasher code is attached to this topic. Compare your exact message with your model manual and do not stand in a different code from the library.
See the research statusWe have not read a full Product Help library for this appliance, so we promise no part and no price in advance. The technician diagnoses on site and agrees the work with you first.

This component has no illustrated glossary entry on the site. Lean on the system described in the text and the model manual cited; a code by itself does not point to a replacement.
Explore the researched partsWhat happens on a visit.
No surprises in your kitchen.

Tell us which appliance, what the display shows and where it is installed. A photo of the model plate helps.

The technician inspects the unit, explains the likely cause and agrees the cost with you before starting.

When the work is done, the technician tests the appliance and walks you through what was fixed.
The page says the internal temperature is too low. Check the door is shut and has not been open long, whether you added a large warm load, and whether the power went out recently.
After a power outage or a restock, allow the temperature to settle before concluding anything is broken.
For CL or LO, E1, E2 and HI or LO, the pages say to switch off the breaker or unplug the unit for one minute, restore power and monitor for another minute.
The E1 and E2 pages print no cause. We say that instead of guessing.
Book us if the code reappears after a full minute without power.
Book us if drinks are warm and the door and load checks are clear.
Book us for water under the unit or a door that will not seal.
Arrange a diagnosticBefore any work begins, the technician tells you what is needed and settles the cost with you. A built-in appliance may need to be examined on site before that figure is firm.
If JennAir's manufacturer warranty covers the repair, JennAir itself does the work. We back our own workmanship with a warranty.
The page says the internal temperature is too low. It asks about the door, a big warm restock and a recent power outage.
The Product Help pages list the codes with a reset only and print no cause. A technician reads the unit.
Switch off the breaker or unplug it for one minute, restore power and watch it for another minute.
JennAir undercounter beverage centers. Add the model number to your booking so the technician arrives knowing the layout.
A beverage center that is still in warranty is the manufacturer’s repair. Past coverage, the technician quotes after the diagnostic and waits for your approval.
Code or symptom, part, service call
CL or LO means the internal temperature is too low. JennAir asks three questions: is the door fully closed, was it restocked with a large warm load, and was there a power outage. Then power down for one minute and back up. HI, LO, E1 and E2 get the same restart.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.