Inside the appliance
Wine cellar over temp alarm. In plain English.
The Over Temp alarm speaks up if either zone stays above its preset range for 10 minutes, with a tone and a flashing light. The tone ends by itself once the cellar is back in range, while the light keeps flashing until you press Reset Alarm.

Where it fits.
Wine cellar over temp alarm in the appliance
The alarm shows on the control. The pages do not locate individual parts.
The picture shows the kind of component only. It cannot tell you which replacement suits your model.
What you notice when this system needs a look.
A Wine cellar over temp alarm concern may show up with a drop in performance or a code that keeps returning. Testing comes first, before anyone decides the component is to blame.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Look at both zones
The alarm watches both zones, so check each one for a warm reading.
- 2
Press Reset Alarm
The indicator keeps flashing until the Reset Alarm touchpad is pressed.
- 3
Expect it back
If the over-temperature condition is still present when you reset, the indicator reactivates every 4 hours.
- 4
Power-cycle for HI, LO, E1, E2
For those codes JennAir says to cut power at the breaker or unplug for one minute, restore it and watch for a minute.
Cleaning or replacement?
Leave internal testing to a technician.
Book us if Over Temp keeps coming back or E1, E2, HI or LO returns after a power reset.
Arrange a diagnosticSources and model boundaries.
The Wine cellar over temp alarm guidance rests on these references. Pick the manual that fits your model.
- Over Temp - Wine Cellar - Product Help | JennAir
- E1 Error Code - Wine Cellar - Product Help | JennAir
- HI or LO Error Code - Wine Cellar - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
When does Over Temp trigger?
When either zone has run above its preset range for 10 minutes.
Does the tone stop on its own?
Yes, once the cellar is back in range. The light keeps flashing until you reset.
Why does the light return?
If the condition persists after a reset, it reactivates every 4 hours.
What about E1, E2 and HI or LO?
JennAir lists a one-minute power cycle for each, then watch whether the code returns.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir wine cellar over temp alarm or HI, LO, E1, E2
Over Temp sounds and flashes when a zone stays above its preset range for 10 minutes. The audio stops by itself when temperature returns to normal, and the light flashes until you press Reset Alarm. For HI, LO, E1 or E2, power the unit off for one minute and back on.
Wine cooler repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.

