Before work starts
Before any work begins, the technician tells you what is needed and settles the cost with you. A built-in appliance may need to be examined on site before that figure is firm.
Independent appliance repair
JennAir undercounter wine cellars and wine columns come to us when they show E1 or E2, run warm or leak. Share the code and the model, then book a technician. The help pages print no cause for the codes, only a reset.

No further researched dishwasher code is attached to this topic. Compare your exact message with your model manual and do not stand in a different code from the library.
See the research statusWe have not read a full Product Help library for this appliance, so we promise no part and no price in advance. The technician diagnoses on site and agrees the work with you first.

This component has no illustrated glossary entry on the site. Lean on the system described in the text and the model manual cited; a code by itself does not point to a replacement.
Explore the researched partsWhat happens on a visit.
No surprises in your kitchen.

Tell us which appliance, what the display shows and where it is installed. A photo of the model plate helps.

The technician inspects the unit, explains the likely cause and agrees the cost with you before starting.

When the work is done, the technician tests the appliance and walks you through what was fixed.
The E1 and E2 pages say to switch off the breaker or unplug the unit for one minute, restore power, and watch it for another minute.
Wine cellar E1 and E2 are listed without a cause. We say so rather than guess, and a technician reads the board.
A door that sits ajar or has stood open lets the cabinet warm. Check the gasket line for anything caught in it.
If the temperature is climbing, move valuable bottles to a cooler spot while you wait for the visit.
Book us if E1 or E2 returns after the one-minute power-down.
Book us if the cellar will not hold its set temperature.
Book us for water pooling under the unit.
Arrange a diagnosticBefore any work begins, the technician tells you what is needed and settles the cost with you. A built-in appliance may need to be examined on site before that figure is firm.
If JennAir's manufacturer warranty covers the repair, JennAir itself does the work. We back our own workmanship with a warranty.
The Product Help pages print the code and a reset, and name no cause. A technician has to read the unit to say what failed.
One minute, by the breaker or by unplugging. Then restore power and watch for another minute.
Yes. Add the model number to your booking so we match the layout.
We cannot judge that remotely. If the cellar is warm, moving valuable bottles somewhere cooler is the careful choice.
A wine cooler inside its manufacturer warranty goes back to the manufacturer. Outside it, we diagnose first and you approve the price before work starts.
Code or symptom, part, service call
Over Temp sounds and flashes when a zone stays above its preset range for 10 minutes. The audio stops by itself when temperature returns to normal, and the light flashes until you press Reset Alarm. For HI, LO, E1 or E2, power the unit off for one minute and back on.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.