What it means
JennAir calls F4E3 a heating error. Take power away for thirty seconds; if F4E3 reappears, book a technician. Leave the parts in the base alone.
JennAir dishwasher F4E3 / Heating
JennAir calls F4E3 a heating error. Take power away for thirty seconds; if F4E3 reappears, book a technician. Leave the parts in the base alone.
Also shown as F4E3
JennAir calls F4E3 a heating error. Take power away for thirty seconds; if F4E3 reappears, book a technician. Leave the parts in the base alone.
If you can, wait before opening the door.
F4E3 returns after the reset.
Checks you have ticked / saved in this browser

If you can, wait before opening the door. A heating error may mean parts are very hot.

Disconnect the machine at the plug or breaker for thirty seconds. Restore power afterward.

A short wash is enough. See whether F4E3 appears again within the first heating phase.

Write down the model, the cycle you ran and when the code returned. That is what a visit will need.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
JennAir F4E2 names the heating system and F4E3 a heating error.
Read the definitionJennAir uses just those two words. Whether sensor, element or control is involved is left open, and we leave it open too. A technician has to measure to know.
Read the supporting manualYes. F4E2 carries the words heating system, while F4E3 carries the words heating error. Both start with the same power cycle.
Read the supporting manualWe suggest not. If the heating cannot be trusted, wash by hand until the visit. Do not run it unattended if the code keeps returning.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2026-06-15; PH 12194 / PH 12194 (dishwasher)
JennAir dishwasher page PH 12194, last modified 2026-06-15. The page's Troubleshooting line is a power cycle; its closing sentence says to schedule service.
JennAir does not say. The page names a heating error only.
A clean filter is good housekeeping, yet nothing on the page links it to this code.
The page offers no auto-clear. If it disappears after the reset, watch for a repeat on the next two or three cycles.
JennAir does not make that claim. Only a test can show the part's condition.
Say: JennAir dishwasher, code F4E3 (heating error), reset once, code returned. Add the model number.
Code or symptom, part, service call
On JennAir's dishwasher page, F4E2 points to the heating system. The one step printed is thirty seconds without power; a repeat means service. The parts under the tub are for a technician only.
JennAir's order is power, then the door and lower rack, then water supply, control lock, delay start, and a one-minute reset. A dishwasher that will not fill adds the drain loop height and an interrupted-cycle flash to the list.
JennAir F4E2 names the heating system and F4E3 a heating error. Each page gives a power cycle and says to schedule service if the code comes back. A heating code can show up as dishes that are wet or not sanitized, so note the cycle you were running.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.