What it means
Showroom Mode is for retail display only. If it was turned on by mistake, Cool Off lights and the controls appear to work, but the cellar is not cooling. Hold COOL ON and SABBATH together for three seconds to exit.
JennAir wine cooler Showroom Mode / Mode, not a failure
Showroom Mode is for retail display only. If it was turned on by mistake, Cool Off lights and the controls appear to work, but the cellar is not cooling. Hold COOL ON and SABBATH together for three seconds to exit.
Also shown as Showroom Mode
Showroom Mode is for retail display only. If it was turned on by mistake, Cool Off lights and the controls appear to work, but the cellar is not cooling. Hold COOL ON and SABBATH together for three seconds to exit.
The guide ties Cool Off to showroom mode.
The cellar is warm a day after exiting.
Checks you have ticked / saved in this browser

The guide ties Cool Off to showroom mode.

Keep both pressed for three seconds.

This turns the cellar on for normal use.

Allow time, and wait 24 hours before adjusting.
Send the model and the checks you have already run, then begin your request from this page.
Book a visitA simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
A mode used only when the wine cellar is on display in a retail store.
Read the supporting manualCool Off lights on the display and the controls appear to work.
Read the supporting manualPress and hold COOL ON and SABBATH at the same time for three seconds.
Read the supporting manualIf the exit does not work or the cellar stays warm for a day afterward.
Read the supporting manualManufacturer document
JennAir (use and care guide)
W11324867 Rev. C / p. 12
Scope: JennAir under counter wine cellar in use and care guide W11324867 Rev. C.
Showroom mode keeps the display and controls alive while cooling stays off.
Cool Off is lit and the controls appear to work.
Three seconds, pressing COOL ON and SABBATH at the same time.
Yes, if the cellar has been warm. Move it while you sort out the mode.
Code or symptom, part, service call
Cool Off on a JennAir wine cellar means cooling is switched off, which is how a new cellar starts when first plugged in. Press COOL ON for three seconds to start cooling and bring up the wine presets and menus.
Over Temp sounds and flashes when a zone stays above its preset range for 10 minutes. The audio stops by itself when temperature returns to normal, and the light flashes until you press Reset Alarm. For HI, LO, E1 or E2, power the unit off for one minute and back on.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.