Inside the appliance
Dishwasher thermistor and OWI sensor. In plain English.
JennAir F3E2 names the thermistor or OWI sensor, the temperature and water sensing part. The page gives a power cycle and says to schedule service if the code returns. It is a good example of a code that names a part and gives the owner a single step.

Where it fits.
Dishwasher thermistor and OWI sensor in the appliance
In the tub base near the heating area, wired to the main control.
The picture shows the kind of component only. It cannot tell you which replacement suits your model.
What you notice when this system needs a look.
A Dishwasher thermistor and OWI sensor concern may show up with a drop in performance or a code that keeps returning. Testing comes first, before anyone decides the component is to blame.

JennAir dishwasher won't start or fill
JennAir's order is power, then the door and lower rack, then water supply, control lock, delay start, and a one-minute reset. A dishwasher that will not fill adds the drain loop height and an interrupted-cycle flash to the list.

JennAir dishwasher lights flashing
Which light flashes decides the answer. A flashing Clean light is usually an F-then-E code, a Sanitize light means the sanitize heat was not reached, and all lights flashing means the door was opened mid-cycle.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Read the code
F3E2 on a display; three flashes, a pause and two flashes on a light model.
- 2
Cycle the power
The Product Help reset for dishwashers is 30 seconds without power: unplug it, or switch the breaker off at the panel, then restore it.
- 3
Run a cycle
Start a normal cycle after the reset and see if the code returns.
- 4
Compare with H2O
H2O (Not Detecting Water) is a supply message. If both codes appear, tell the technician.
Cleaning or replacement?
Leave internal testing to a technician.
Book us if F3E2 returns after the reset.
Book us if cycles run much longer or shorter than usual.
Book us if the dishwasher seems to misjudge fill or heat.
Arrange a diagnosticSources and model boundaries.
The Dishwasher thermistor and OWI sensor guidance rests on these references. Pick the manual that fits your model.
- F3E2- Dishwasher - Product Help | JennAir
- H2O - Dishwasher - Product Help | JennAir
- Dishwasher Error Codes - Reading - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
What is an OWI sensor?
The page uses the term without defining it. It sits with the thermistor as the potential cause of F3E2. A technician identifies it by model.
Can I test the thermistor at home?
The help page gives no test. It lists a power cycle and service.
Does this code stop the dishwasher?
The page does not say. Run a cycle after the reset and note whether it completes.
Is it related to F4E2?
They are separate codes. F4E2 names the heating system, F3E2 the sensor. A technician may check both.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir dishwasher won't start or fill
JennAir's order is power, then the door and lower rack, then water supply, control lock, delay start, and a one-minute reset. A dishwasher that will not fill adds the drain loop height and an interrupted-cycle flash to the list.
Dishwasher repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.

