Inside the appliance
Ice maker cutting grid. In plain English.
The cutting grid divides the ice sheet into cubes after it slides off the evaporator plate. JennAir says ice can stick between the plate and the grid. The listed causes are an unlevel machine, an unplugged grid harness and mineral buildup that needs a clean cycle.

Where it fits.
Ice maker cutting grid in the appliance
The page places it against the evaporator plate inside the ice maker, with a harness that plugs in. It gives no other position.
The picture shows the kind of component only. It cannot tell you which replacement suits your model.
What you notice when this system needs a look.
A Ice maker cutting grid concern may show up with a drop in performance or a code that keeps returning. Testing comes first, before anyone decides the component is to blame.

JennAir ice maker not making ice or stopped
When a freestanding ice maker goes quiet, look for a dirty or blocked bin sensor, a cracked or badly locked water filter, or a cleaning cycle that was cut short. Check those, level the unit and restart it. A service light that returns means a repair.

JennAir ice maker noises: normal and not
Most ice maker noises are normal: splashing, water running when it starts, a bang as ice drops, and the reservoir overflowing. A loud high-pitched sound while filling can mean supply pressure above 60 psi, where 50 psi is recommended.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Level the ice maker
A level machine lets the ice slide off the evaporator plate properly.
- 2
Check the grid harness
Verify the grid harness is securely plugged in.
- 3
Run a clean cycle
Mineral buildup can hold ice on the grid. Use one 16-ounce bottle of approved ice maker cleaner; JennAir names affresh Ice Machine Cleaner W11179302.
- 4
Let it finish
The Clean light blinks during the cycle, which takes about 70 to 90 minutes, and the display shows Cleaning Complete.
Cleaning or replacement?
Leave internal testing to a technician.
Book us if ice keeps sticking after leveling, the harness check and a full clean cycle.
Arrange a diagnosticSources and model boundaries.
The Ice maker cutting grid guidance rests on these references. Pick the manual that fits your model.
- Why is Ice Stuck on the Cutting Grid - Product Help | JennAir
- Cleaning Light Blinking - Freestanding Ice Maker - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
Why is ice stuck on the grid?
JennAir lists an unlevel unit, an unplugged grid harness and mineral buildup.
How much cleaner do I use?
One 16-ounce (473 mL) bottle of approved ice maker cleaner.
How long is the clean cycle?
About 70 to 90 minutes. The Clean light blinks until Cleaning Complete shows.
What if the cycle stops early?
The Clean light keeps blinking. Press Clean to resume.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir ice maker not making ice or stopped
When a freestanding ice maker goes quiet, look for a dirty or blocked bin sensor, a cracked or badly locked water filter, or a cleaning cycle that was cut short. Check those, level the unit and restart it. A service light that returns means a repair.
Ice maker repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.

