What it means
MAX COOL is a feature, not an error. It drives the cabinet to its lowest temperature for 24 hours. Press MAX COOL to turn it on, and press it again to turn it off and return to your previous settings.
JennAir beverage center MAX COOL / Mode, not a failure
MAX COOL is a feature, not an error. It drives the cabinet to its lowest temperature for 24 hours. Press MAX COOL to turn it on, and press it again to turn it off and return to your previous settings.
Also shown as MAX COOL
MAX COOL is a feature, not an error. It drives the cabinet to its lowest temperature for 24 hours. Press MAX COOL to turn it on, and press it again to turn it off and return to your previous settings.
The feature activates at once.
The cabinet is not colder 12 hours into MAX COOL.
Checks you have ticked / saved in this browser

The feature activates at once.

The beverage center returns to the previous settings.

The guide describes the lowest point for 24 hours, so bottles chill faster during the run.

If the cabinet is warm with cooling on, MAX COOL will not cure a cooling problem. Book a visit.
Send the model and the checks you have already run, then begin your request from this page.
Book a visitA simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
A feature that drives the cabinet to its lowest temperature for 24 hours.
Read the supporting manualPress MAX COOL to switch it on, and press MAX COOL again to switch it off and return to the previous settings.
Read the supporting manualYour regular set points come back when the feature ends or is turned off.
Read the supporting manualIf the cabinet does not get colder during MAX COOL, the cooling system is not keeping up. That is a diagnosis for us.
Read the supporting manualManufacturer document
JennAir (use and care guide)
W11325206 Rev. C / p. 12
Scope: JennAir under counter beverage center in use and care guide W11325206 Rev. C.
For 24 hours, according to the guide.
It overrides them while it runs. Turning it off returns the previous settings.
MAX COOL drives the cabinet to its lowest temperature, so everything cools harder than at the set point.
The guide gives a 24-hour run. Turn it off when the load is cold to return to normal operation.
Code or symptom, part, service call
Cool Off means cooling is switched off, not that something has failed. It is how a new JennAir beverage center starts after it is first plugged in. Press COOL ON for three seconds to turn the beverage center on.
CL or LO means the internal temperature is too low. JennAir asks three questions: is the door fully closed, was it restocked with a large warm load, and was there a power outage. Then power down for one minute and back up. HI, LO, E1 and E2 get the same restart.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.