What it means
F36 on a JennAir induction cooktop may point at a coil temperature sensor. Switch the breaker off for one minute, switch it back on, and watch the cooktop for one minute.
JennAir cooktop F36 / Temperature and overheat
F36 on a JennAir induction cooktop may point at a coil temperature sensor. Switch the breaker off for one minute, switch it back on, and watch the cooktop for one minute.
Also shown as F36
F36 on a JennAir induction cooktop may point at a coil temperature sensor. Switch the breaker off for one minute, switch it back on, and watch the cooktop for one minute.
Coil sensors sit under the glass.
F36 returns after the reset.
Checks you have ticked / saved in this browser

Stop cooking on the affected zone while you test.

Power the cooktop down at its breaker for a minute, bring it back up, and give the zone that showed the code a minute of observation.

See whether F36 returns on the same zone or on a different one.

This helps a technician target the coil.
Send the model and the checks you have already run, then begin your request from this page.
Book a visitA simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
A temperature sensor on one of the induction coils may be the problem.
Read the supporting manualPower the cooktop down at its breaker for a minute, bring it back up, and give the zone that showed the code a minute of observation.
Read the supporting manualJennAir titles the page F36, F37 and lists one set of steps.
Read the supporting manualIf F36 comes back after the reset, a coil sensor or its wiring needs testing on site.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2022-03-24; PH 11908 / PH 11908 (electric and induction cooktop)
Scope: JennAir induction cooktops. The Product Help page is titled F36, F37 and covers both codes (PH 11908).
JennAir says a temperature sensor on an induction coil may be the problem.
JennAir groups F36 and F37 on one page with the same text. We treat F37 as its own code.
It is the only step the page gives. Switch the breaker off for one minute and on again.
The page does not say. Treat the cooktop as unsafe to rely on until it is checked.
Code or symptom, part, service call
F21 on a JennAir radiant, electric or induction cooktop points to the cooktop overheating. Verify the installation, let the cooktop cool for about five minutes, then switch the breaker off for one minute and on again.
Clicking with no flame points to a short list: Control Lockout after a power loss, a closed gas shut-off, a knob not turned to Ignite, moisture, or clogged ports. On a first start JennAir says to turn one knob for a moment so air leaves the line.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.