What it means
A flashing Clean light usually carries an error code in two bursts. The first burst of rapid flashes is the F number; after a pause of a second or two, the second burst is the E number. Seven then one reads F7E1.
JennAir dishwasher Clean light flashing (reading rule) / Indicator lights
A flashing Clean light usually carries an error code in two bursts. The first burst of rapid flashes is the F number; after a pause of a second or two, the second burst is the E number. Seven then one reads F7E1.
Also shown as Clean light flashing (reading rule)
A flashing Clean light usually carries an error code in two bursts. The first burst of rapid flashes is the F number; after a pause of a second or two, the second burst is the E number. Seven then one reads F7E1.
Let the light run through one whole sequence first.
The Clean light keeps flashing in a pattern you cannot match to the code list.
Checks you have ticked / saved in this browser

Let the light run through one whole sequence first. You are looking for a clear pause between two sets of flashes.

Count the rapid flashes before the short pause. That number is the Function, or F, part of the code.

After the one to two second pause, count the next set. That is the Error, or E, number.

A pause of about five seconds comes before the sequence starts again. Count a second time to confirm, then find the page for that code.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
JennAir says it usually means an error code is being communicated. The dishwasher uses a two-part flashing sequence, so one blinking light can carry a full code such as F7E1.
Read the supporting manualCount the first set of quick flashes, note the short pause, and count the second set. Together they give the F number and the E number. A gap of roughly five seconds separates one repetition from the next.
Read the supporting manualAny F#E# code on a model without a text display. This site has pages for the F#E# codes JennAir prints, and a separate page for codes that JennAir does not list.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2026-06-15; PH 12183 / PH 12183 (dishwasher)
Covers the Clean light on JennAir dishwashers that blink their codes. Source: product page PH 12183, last modified 2026-06-15.
JennAir also writes FAE4 and FAE5 as F10E4 and F10E5, which means ten flashes can stand in for the A.
Count again from the moment the light restarts after the long pause.
Usually, but not always. All cycle lights flashing together means a paused cycle, which is a different page.
Yes. A short video lets you count slowly later and is useful to show a technician.
Use the not-listed page here. It explains what to do for a code JennAir does not print.
Code or symptom, part, service call
F9E1 on a JennAir dishwasher is listed as Long Drain, meaning the water is not leaving the tub. The page's checks run from the filter to the drain hose, the sink disposer knockout plug on a new installation, the air gap and suds. Cycle the power after the checks.
JennAir's order is power, then the door and lower rack, then water supply, control lock, delay start, and a one-minute reset. A dishwasher that will not fill adds the drain loop height and an interrupted-cycle flash to the list.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.