What it means
F2H1 points at the switch that runs the vent fan and light, found on the lower left front side panel, or at its wiring. Turn the microwave breaker off for a minute, then on.
JennAir microwave F2H1 / Fans and ventilation
F2H1 points at the switch that runs the vent fan and light, found on the lower left front side panel, or at its wiring. Turn the microwave breaker off for a minute, then on.
Also shown as F2H1
F2H1 points at the switch that runs the vent fan and light, found on the lower left front side panel, or at its wiring. Turn the microwave breaker off for a minute, then on.
Leave it off for a minute, then switch it on.
F2H1 returns after the reset.
Checks you have ticked / saved in this browser

Leave it off for a minute, then switch it on.

See whether F2H1 returns.

Press the vent fan and light controls after the reset and see if both respond.
The fan, the light, or both.
Send the model and the checks you have already run, then begin your request from this page.
Book a visitThe switch that runs the vent fan and light, or its wiring, may be the problem.
Read the supporting manualTurn off the microwave breaker for sixty seconds, switch it on again, and keep an eye on the display for a minute.
Read the supporting manualPress their controls after the reset. If both respond normally, F2H1 may have been a one-off.
Read the supporting manualIf F2H1 returns or the fan or light stays dead.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2021-04-27; PH 9603 / PH 9603 (over-the-range microwave)
Scope: JennAir over-the-range microwave. Read from the JennAir Product Help page for this code in the over-the-range microwave error code tree (November 2026).
JennAir places the switch on the lower left front side panel.
The page does not say. Test the fan and light after the reset.
No. A blocked vent is F7E9.
The page offers only the reset. Switch replacement needs a technician.
Code or symptom, part, service call
F7E9 asks whether the vent is blocked. The upper vent door must open and close freely; trim, cabinetry or something else in the way could let the microwave overheat. Clear it, then turn the breaker off for a minute and back on.
First confirm the controls: enter Cook Time, then Cook Power if it is not 100%, and press Start. Then test with one cup of water for one minute on HI. If heat rise is detected, the microwave is heating. With no power at all, check the breaker or fuse.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.