What it means
F3T3 points at the thermistor that reads hood temperature, or at its wiring. Shut off the microwave breaker for a minute, switch it on, and keep the oven in view for a minute.
JennAir microwave F3T3 / Sensors
F3T3 points at the thermistor that reads hood temperature, or at its wiring. Shut off the microwave breaker for a minute, switch it on, and keep the oven in view for a minute.
Also shown as F3T3
F3T3 points at the thermistor that reads hood temperature, or at its wiring. Shut off the microwave breaker for a minute, switch it on, and keep the oven in view for a minute.
One minute off, then on again.
F3T3 returns after the reset.
Checks you have ticked / saved in this browser

One minute off, then on again.

Check F3T3 does not return in the first minute.

Try the vent and a short cycle.

Heavy cooking below the hood just before the code is worth mentioning.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit


A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
The thermistor that reads hood temperature, or its wiring, may be the problem.
Read the supporting manualShut off the breaker for sixty seconds, switch it on and keep the oven in view for the next minute.
Read the supporting manualF3T4 is the magnetron thermistor.
Read the supporting manualIf F3T3 returns after a reset.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2021-04-27; PH 9612 / PH 9612 (over-the-range microwave)
Scope: JennAir over-the-range microwave. Read from the JennAir Product Help page for this code in the over-the-range microwave error code tree (November 2026).
JennAir names it as the part that may have a problem. The page does not describe where it sits.
F3T4 names the magnetron temperature thermistor. They are two different sensors.
It can clear a brief reading error.
The page does not say. Test the hood after the reset.
Code or symptom, part, service call
F3T4 says there may be a problem with the magnetron temperature thermistor or the associated wiring. Turn off the microwave breaker for a minute, turn it on, and keep the oven in view for a minute.
First confirm the controls: enter Cook Time, then Cook Power if it is not 100%, and press Start. Then test with one cup of water for one minute on HI. If heat rise is detected, the microwave is heating. With no power at all, check the breaker or fuse.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.