What it means
Treat 1c8c as a flag on the electronic control, wiring second. Kill the breaker for 60 seconds, bring back power, then observe for the code.
JennAir oven 1c8c / Oven control
Treat 1c8c as a flag on the electronic control, wiring second. Kill the breaker for 60 seconds, bring back power, then observe for the code.
Also shown as 1c8c
Treat 1c8c as a flag on the electronic control, wiring second. Kill the breaker for 60 seconds, bring back power, then observe for the code.
Wait for the racks and glass time to cool with 1c8c showing.
1c8c returns after the breaker reset.
Checks you have ticked / saved in this browser

Wait for the racks and glass time to cool with 1c8c showing.

Use the breaker, not the oven keys; after a minute, check for 1c8c again.

Cycle, setting and time when 1c8c appeared help the visit.

An oven control is mounted behind the front, so no visual check settles it; testing is what settles it on a visit for 1c8c.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
The electronic control is the board that manages the oven functions.
Read the definitionOn 1c8c JennAir stays careful: the oven control may be involved. A lead, not a verdict.
Read the supporting manualReset the power for 60 seconds, bring it back and keep an eye on the oven one minute. Call us if 1c8c comes back.
Read the supporting manualThat is our judgment, not JennAir's: use the oven only while it behaves. Smoke, sparks or tripping mean switch off plus a technician.
Read the supporting manualFor 1d11 JennAir lists the temperature sensor or the oven control; for 1c8c it lists the electronic control.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-08-16; PH 12896 / PH 12896 (range)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13270 / PH 13270 (wall oven)
Scope: freestanding range and wall oven. Read from JennAir Product Help, PH 12896, PH 13270. Neighbors of 1c8c use similar wording.
Product Help lists the oven control or connected wiring as suspects for 1c8c.
Breaker off for a minute, then on, then monitor 1c8c for 60 seconds.
Better not with 1c8c showing. Do the reset first, then cook only if it behaves.
Not by itself. The page for 1c8c names suspects only.
Code or symptom, part, service call
1d11 starts JennAir's "Starts with 1d" group and lists the temperature sensor and the control, or the wiring between them. The first step is a sixty-second power reset at the breaker panel; call for service if it returns.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
The electronic control is the board that manages the oven functions. JennAir names it in F1 E1, F3 and F4 codes, and as the shared suspect in many sensor and keypad codes. The help pages give one owner step, a one-minute power-down, and do not name a repair.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.