What it means
F1E3 on a JennAir combination wall oven names the microwave appliance manager or its wiring. The page asks for a one-minute breaker reset: switch off, turn back on, then watch the oven for a minute to see whether the code returns.
JennAir oven F1E3 / Microwave (combination oven)
F1E3 on a JennAir combination wall oven names the microwave appliance manager or its wiring. The page asks for a one-minute breaker reset: switch off, turn back on, then watch the oven for a minute to see whether the code returns.
Also shown as F1E3
F1E3 on a JennAir combination wall oven names the microwave appliance manager or its wiring. The page asks for a one-minute breaker reset: switch off, turn back on, then watch the oven for a minute to see whether the code returns.
Do not run the microwave section while F1E3 is displayed, and keep the cavity free of metal.
F1E3 returns after the reset.
Checks you have ticked / saved in this browser

Do not run the microwave section while F1E3 is displayed, and keep the cavity free of metal.

Switch the oven's breaker off for a full minute, then on again.

After power returns, keep an eye on the display for another minute.

Combination wall oven models differ. Note the model number for the visit.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
JennAir ranges and wall ovens with several cavities use an appliance manager that coordinates the oven controls.
Read the definitionJennAir says there may be a problem with the microwave appliance manager or the wiring that serves it.
Read the supporting manualIt is the module that coordinates the microwave section's functions on a combination oven. This is our general description.
Read the supporting manualReset the power at the breaker for one minute, restore it and watch the oven for one minute.
Read the supporting manualF1E4 adds the microwave power relay to the appliance manager. F1E3 names only the manager. Check which you have.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13317 / PH 13317 (wall oven)
Scope: combination wall oven only. Read from JennAir Product Help PH 13317.
The page names a microwave part, so that section is most likely involved. It does not say the lower oven is affected.
If the baking cavity works normally after the reset, light use is reasonable. Avoid the microwave until a technician checks.
Yes.
Book a visit and mention the code, the model and the reset result.
Code or symptom, part, service call
F1 lists the temperature sensor and the control, or the wiring between them on both JennAir ranges and wall ovens. The first step is a sixty-second power reset at the breaker panel; call for service if it returns.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
JennAir ranges and wall ovens with several cavities use an appliance manager that coordinates the oven controls. The F6 family names it, sometimes with the converter control or the user interface. The pages admit there are many possible reasons, then give one reset.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.