What it means
F1E6 on a JennAir combination wall oven names the microwave thermistor or sensor, or the wiring that serves it. The printed step is a one-minute breaker reset followed by a minute of watching. Book a technician if F1E6 returns.
JennAir oven F1E6 / Microwave (combination oven)
F1E6 on a JennAir combination wall oven names the microwave thermistor or sensor, or the wiring that serves it. The printed step is a one-minute breaker reset followed by a minute of watching. Book a technician if F1E6 returns.
Also shown as F1E6
F1E6 on a JennAir combination wall oven names the microwave thermistor or sensor, or the wiring that serves it. The printed step is a one-minute breaker reset followed by a minute of watching. Book a technician if F1E6 returns.
Do not heat anything in the microwave section while F1E6 is showing, because the sensor involved reports temperature.
F1E6 returns after the breaker reset.
Checks you have ticked / saved in this browser

Do not heat anything in the microwave section while F1E6 is showing, because the sensor involved reports temperature.

Use the breaker that feeds the wall oven, wait a full minute and switch it back on.

JennAir wants you to see whether F1E6 returns before treating the reset as a success.

Write down whether the microwave, the lower oven or neither was running when F1E6 appeared.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
JennAir lists the microwave thermistor or sensor, or the wiring, as the possible trouble spot.
Read the supporting manualIt is a small sensor whose electrical resistance changes with temperature, so the control can read heat. That is general background from us.
Read the supporting manualSwitch the breaker off for one minute, restore power and monitor the oven for one minute.
Read the supporting manualIf the baking cavity heats normally after the reset, careful use is reasonable. Leave the microwave idle until a technician has looked.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13320 / PH 13320 (wall oven)
Scope: combination wall oven only. Read from JennAir Product Help PH 13320.
No. The page names the microwave thermistor or sensor, which is a different sensor from the oven's temperature probe.
Only the combination wall oven has the microwave section, so only its page prints F1E6.
Yes. JennAir's page title writes it with a space.
The code, the model and whether the microwave or the main oven was in use. Also mention the result of the breaker reset.
Code or symptom, part, service call
F1 lists the temperature sensor and the control, or the wiring between them on both JennAir ranges and wall ovens. The first step is a sixty-second power reset at the breaker panel; call for service if it returns.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.