What it means
F5 E7 names the lock assembly, the switch or the wiring behind them on both a JennAir freestanding range and a wall oven. Close the door squarely, then cycle the breaker for about a minute.
JennAir oven F5E7 / Door latch and switch
F5 E7 names the lock assembly, the switch or the wiring behind them on both a JennAir freestanding range and a wall oven. Close the door squarely, then cycle the breaker for about a minute.
Also shown as F5E7
F5 E7 names the lock assembly, the switch or the wiring behind them on both a JennAir freestanding range and a wall oven. Close the door squarely, then cycle the breaker for about a minute.
Latch hardware should not be tested hot.
F5 E7 returns after the reset.
Checks you have ticked / saved in this browser

Latch hardware should not be tested hot.

A rack tip, a pan handle or a towel can stop the door seating.

Restore power and monitor the display for a minute.

Check that the oven holds temperature and the code stays clear.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
The latch assembly and its door switch lock the oven door for self-clean and report that the door is closed.
Read the definitionOn both the range and the wall oven pages, with identical wording. No professional-style range page is printed for it.
Read the supporting manualThe door latch assembly, the door switch and the wiring. That covers the lock, the sensor that reports it and the cable between them.
Read the supporting manualOn a range E5 mentions hinges and gasket. E7 sticks to the latch hardware, so a range showing E7 is less likely to be a gasket issue.
Read the supporting manualIf a reset clears the code and the oven bakes normally, carry on and watch for a repeat. If not, book a visit.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-08-16; PH 12979 / PH 12979 (range)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13364 / PH 13364 (wall oven)
PH 12979, 13364: F5E7, range/wall-oven.
JennAir lists it as a possibility only. A technician tests the switch and wiring before replacing anything.
Not while the code shows, and it is wise to wait until it has stayed away for several uses.
The page concerns the oven door. A range cooktop is separate.
JennAir prints one meaning for both product types, so the same checks apply.
Code or symptom, part, service call
F5 points at the door latch assembly or its switches on a JennAir freestanding range or wall oven, and at nothing in particular on a steam oven, where the page is only a reset. Close the door fully, then drop the breaker for a single minute and restore it.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
The latch assembly and its door switch lock the oven door for self-clean and report that the door is closed. JennAir lists them for F5 codes and F7 E0, and for the locked-door and door-will-not-close pages. A bent latch arm is one check you can do yourself.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.