What it means
F7 E0 means a door latch assembly or its wiring on a JennAir freestanding range, but a water level or water level sensor on a wall oven. Work out your product type, then cycle the breaker for 60 seconds.
JennAir oven F7E0 / Door latch and switch
F7 E0 means a door latch assembly or its wiring on a JennAir freestanding range, but a water level or water level sensor on a wall oven. Work out your product type, then cycle the breaker for 60 seconds.
Also shown as F7E0
F7 E0 means a door latch assembly or its wiring on a JennAir freestanding range, but a water level or water level sensor on a wall oven. Work out your product type, then cycle the breaker for 60 seconds.
Range or wall oven.
F7 E0 returns after the reset.
Checks you have ticked / saved in this browser

Range or wall oven. The two pages name entirely different parts.

Make sure no rack tip or towel keeps it from seating on the latch.

If your oven has a water container, confirm it is seated and filled as your manual describes.

After power returns, watch the control panel.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
The latch assembly and its door switch lock the oven door for self-clean and report that the door is closed.
Read the definitionIt names the oven door latch assembly or the wiring. That is a lock problem, not a water problem, and the door checks above are the relevant ones.
Read the supporting manualIt names the water level, the water level sensor or the wiring. That wording fits an oven with a water system, though JennAir's page does not use the word steam.
Read the supporting manualThe one for your product. A range owner reading the wall oven row will hunt for water that does not exist on that appliance.
Read the supporting manualWhen the code returns after the reset or the oven refuses to start a cycle.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-01-08; PH 12987 / PH 12987 (range)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13378 / PH 13378 (wall oven)
PH 12987, 13378: F7E0, range/wall-oven.
The page does not say so. It lists a level or a sensor, which are readings rather than leaks.
On a range both rows can involve the door latch, but they are separate codes.
Follow your own manual for the fill procedure; the Product Help page gives no fill steps.
Not stated. Try a simple bake after the reset.
Code or symptom, part, service call
JennAir prints no plain F7. Every F7 page carries an E digit, and the same digit names different parts on a range, a wall oven and a professional-style range. Find the E number on your display and choose the page for your product type.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
The latch assembly and its door switch lock the oven door for self-clean and report that the door is closed. JennAir lists them for F5 codes and F7 E0, and for the locked-door and door-will-not-close pages. A bent latch arm is one check you can do yourself.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.