What it means
F9-1 on a JennAir freestanding range names the oven door latch, the door lock switch or the wiring. Close the door squarely, then reset the breaker for about a minute and watch the display.
JennAir oven F9-1 / Door latch and switch
F9-1 on a JennAir freestanding range names the oven door latch, the door lock switch or the wiring. Close the door squarely, then reset the breaker for about a minute and watch the display.
Also shown as F9-1
F9-1 on a JennAir freestanding range names the oven door latch, the door lock switch or the wiring. Close the door squarely, then reset the breaker for about a minute and watch the display.
The latch works at the hottest point of the door.
F9-1 returns after the reset.
Checks you have ticked / saved in this browser

The latch works at the hottest point of the door.

A rack tip or a towel keeps it from seating.

Restore and watch for another minute.

Cleaning relies on the lock.
Send the model and the checks you have already run, then begin your request from this page.
Book a visitA simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
JennAir prints F9-1, F9-2 and F9-3 as three separate range pages with the same latch wording.
Read the supporting manualIt tells the control the lock is engaged. The latch moves the bolt; the switch reports it.
Read the supporting manualA wall oven F9 is a supply wiring message. A range F9-1 is a door-lock message. Do not mix the two.
Read the supporting manualIf F9-1 returns after a reset, or the door will not latch.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-08-16; PH 12993 / PH 12993 (range)
PH 12993: F9-1, range.
The pages do not rank them. F9-1, F9-2 and F9-3 carry the same latch wording on the range, so treat each as a door-lock message and handle it the same way.
Maybe, if the oven starts. The code concerns the door latch, so close the door squarely and reset the breaker first, then see whether a normal bake begins.
No. The door latch and lock switch sit in the oven door area and need a technician. Close the door squarely and clear anything blocking it, then book a visit if the code returns.
Yes, cleaning relies on the door lock, so hold off on self-clean until F9-1 stays clear after a reset.
Code or symptom, part, service call
F9 on a JennAir wall oven most often means the oven was wired wrongly at the home supply or the hard-wire connection, with L2 and N swapped as the example; a steam oven page gives only a reset. Call an electrician before using the oven again.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.