What it means
F9-3 closes the hyphen series on a JennAir freestanding range with the same wording as F9-1 and F9-2: door latch, door lock switch or wiring. Close the door, reset the breaker for a single minute and watch.
JennAir oven F9-3 / Door latch and switch
F9-3 closes the hyphen series on a JennAir freestanding range with the same wording as F9-1 and F9-2: door latch, door lock switch or wiring. Close the door, reset the breaker for a single minute and watch.
Also shown as F9-3
F9-3 closes the hyphen series on a JennAir freestanding range with the same wording as F9-1 and F9-2: door latch, door lock switch or wiring. Close the door, reset the breaker for a single minute and watch.
Cooling first keeps your hands safe.
F9-3 returns after the reset.
Checks you have ticked / saved in this browser

Cooling first keeps your hands safe.

Do not slam it; seat it and check it sits flush.

Power it up again and look at the display.

So you can tell which part of the range is reporting.
Send the model and the checks you have already run, then begin your request from this page.
Book a visitA simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
It lists the oven door latch, the door lock switch or the wiring that connects them, then gives the usual breaker steps.
Read the supporting manualAs one family. If F9-1 earlier cleared with a reset and F9-3 now appears, treat that as a sign the lock hardware is wearing, not as three unrelated events.
Read the supporting manualNo. The wall oven page for plain F9 is about wiring at the supply. This range code is about the door lock.
Read the supporting manualOne reset and one test bake. If F9-3 returns, book.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-08-16; PH 12995 / PH 12995 (range)
PH 12995: F9-3, range.
JennAir prints F9-1, F9-2 and F9-3. No F9-4 page is printed.
No. It lists the latch, the switch or wiring as possibilities.
The page concerns the oven door. Cooktop burners are separate.
Not for this code. The wiring in question is inside the range, so a technician handles it.
Code or symptom, part, service call
F9 on a JennAir wall oven most often means the oven was wired wrongly at the home supply or the hard-wire connection, with L2 and N swapped as the example; a steam oven page gives only a reset. Call an electrician before using the oven again.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.