Inside the appliance
Main gas shut-off valve. In plain English.
The main gas shut-off valve feeds the cooktop. JennAir says to confirm it is ON if the cooktop does not work. With a lever ball valve, the handle in line with the pipe means gas flows, and across the pipe means it is cut off.

Where it fits.
Main gas shut-off valve in the appliance
Usually in the cabinet below or adjacent to the cooktop. JennAir suggests a local technician if you cannot find it.
The picture shows the kind of component only. It cannot tell you which replacement suits your model.
What you notice when this system needs a look.
A Main gas shut-off valve concern may show up with a drop in performance or a code that keeps returning. Testing comes first, before anyone decides the component is to blame.

JennAir gas cooktop burner clicks but will not light
Clicking with no flame points to a short list: Control Lockout after a power loss, a closed gas shut-off, a knob not turned to Ignite, moisture, or clogged ports. On a first start JennAir says to turn one knob for a moment so air leaves the line.

JennAir cooktop not powering on or nothing works
For a cooktop that does nothing, JennAir starts with the controls, the control or cooktop lock, the cord and the breaker. On an electric cooktop, turn the breaker off for one minute and back on. On a gas cooktop, also confirm that gas reaches it and the shut-off valve stands open.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Find the valve
It is usually in the cabinet below or beside the cooktop, on the gas branch piping.
- 2
Read the handle
Parallel to the line is open, perpendicular is closed, for most lever ball valves.
- 3
Release air
On a new installation, turn a burner on for a moment to release air from the gas line.
- 4
Care with the flex line
Do not kink or pinch the flexible supply line to the regulator.
Cleaning or replacement?
Leave internal testing to a technician.
Book us if the valve is open and burners still will not light.
If you smell gas, leave the area and call your gas utility.
Arrange a diagnosticSources and model boundaries.
The Main gas shut-off valve guidance rests on these references. Pick the manual that fits your model.
- Checking the Main Gas Valve - Product Help | JennAir
- Nothing Will Work - Gas Cooktop - Product Help | JennAir
- Gas Burners are Clicking but Not Lighting - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
Where is the shut-off valve?
Typically in the cabinet below or next to the cooktop.
Which way is open?
On a lever ball valve, handle parallel to the pipe is open.
Why check it?
A closed valve means burners click but never light.
Does a recent installation matter?
Yes. Air in the line can delay lighting until a burner has run briefly.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir gas cooktop burner clicks but will not light
Clicking with no flame points to a short list: Control Lockout after a power loss, a closed gas shut-off, a knob not turned to Ignite, moisture, or clogged ports. On a first start JennAir says to turn one knob for a moment so air leaves the line.
Cooktop repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.

