Inside the appliance
Surface burner igniter. In plain English.
JennAir cooktops light with electronic igniters, not standing pilots. Push the knob in and turn it counterclockwise to Ignite, wait for the flame, then set Hi to Lo. Some models re-ignite a burner that goes out, and a downdraft can make them keep sparking.

Where it fits.
Surface burner igniter in the appliance
The page says surface burners use electric igniters. It gives no more detail on position.
The picture shows the kind of component only. It cannot tell you which replacement suits your model.
What you notice when this system needs a look.
A Surface burner igniter concern may show up with a drop in performance or a code that keeps returning. Testing comes first, before anyone decides the component is to blame.

JennAir gas cooktop burner clicks but will not light
Clicking with no flame points to a short list: Control Lockout after a power loss, a closed gas shut-off, a knob not turned to Ignite, moisture, or clogged ports. On a first start JennAir says to turn one knob for a moment so air leaves the line.

JennAir cooktop not powering on or nothing works
For a cooktop that does nothing, JennAir starts with the controls, the control or cooktop lock, the cord and the breaker. On an electric cooktop, turn the breaker off for one minute and back on. On a gas cooktop, also confirm that gas reaches it and the shut-off valve stands open.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Use the Ignite step
Push the knob in, turn it to Ignite, wait until you see a flame, then choose a setting.
- 2
Check the lockout
After a power failure the burners can be in Control Lockout. Touch the lock key for 3 seconds to unlock.
- 3
Dry the area
Moisture can make burners click on their own.
- 4
Mind the downdraft
If it keeps sparking on a lit burner, reduce the blower speed or increase the flame.
Cleaning or replacement?
Leave internal testing to a technician.
Book us if there is no click, or sparking continues with a dry cooktop and the downdraft off.
Arrange a diagnosticSources and model boundaries.
The Surface burner igniter guidance rests on these references. Pick the manual that fits your model.
- Lighting the Burners - Electronic Ignition - Product Help | JennAir
- Gas Burners are Clicking but Not Lighting - Product Help | JennAir
- Surface Burner(s) Sparking or Clicking - Commercial Range - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
Do all burners click when I push in a knob?
Yes, but only the one turned to Ignite lights.
What if there is no spark?
JennAir says to turn the burner off and check for a tripped breaker or blown fuse.
Why does it keep clicking after it lights?
The re-ignition feature sparks if a flame goes out, and drafts or a downdraft can trigger it.
Can the lock stop burners?
Yes. Clicking can happen while the burner will not light.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir gas cooktop burner clicks but will not light
Clicking with no flame points to a short list: Control Lockout after a power loss, a closed gas shut-off, a knob not turned to Ignite, moisture, or clogged ports. On a first start JennAir says to turn one knob for a moment so air leaves the line.
Cooktop repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.

