Inside the appliance
Microwave control lock. In plain English.
The Control Lock turns off the control panel pads so the microwave cannot be started by accident. JennAir lists it for both a start button that does nothing and a microwave that has power but will not run.

Where it fits.
Microwave control lock in the appliance
It is set from the control panel pads.
The picture shows the kind of component only. It cannot tell you which replacement suits your model.
What you notice when this system needs a look.
A Microwave control lock concern may show up with a drop in performance or a code that keeps returning. Testing comes first, before anyone decides the component is to blame.

JennAir built-in microwave not heating
First confirm the controls: enter Cook Time, then Cook Power if it is not 100%, and press Start. Then test with one cup of water for one minute on HI. If heat rise is detected, the microwave is heating. With no power at all, check the breaker or fuse.

JennAir built-in microwave will not start
A microwave that has power but will not start is usually blocked by the door, the Control Lock, Demo Mode or a blank Energy Save display. Confirm that nothing stops the door shutting, check the lock, then switch the breaker off for a minute.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Check the lock
With Control Lock on, the microwave will not start. Your manual gives the steps to turn it off.
- 2
Reset the power
Leave the breaker off for a minute, switch it back on and test again.
- 3
Check the heating
To test heat, run one cup of water for 1 minute on HI and look for a rise in temperature.
- 4
Check the display
A blank display can be Energy Save mode, or a power reset may be needed.
Cleaning or replacement?
Leave internal testing to a technician.
Book us if the pads do nothing with the lock off and power reset.
Arrange a diagnosticSources and model boundaries.
The Microwave control lock guidance rests on these references. Pick the manual that fits your model.
- Start Button Not Working - Built-In Microwave - Product Help | JennAir
- Not Operating - Has Power - Built-In Microwave - Product Help | JennAir
- Not Heating - Built-In Microwave - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
Why is the Start button dead?
The Control Lock may be on. It disables the control panel pads.
How do I turn it off?
The page points to your owner’s manual, since steps vary by model.
How do I test heating?
Run a cup of water 1 minute on HI. If it warms, the microwave heats.
What if the display is blank?
It may be in Energy Save mode, or try a one-minute breaker reset.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir built-in microwave not heating
First confirm the controls: enter Cook Time, then Cook Power if it is not 100%, and press Start. Then test with one cup of water for one minute on HI. If heat rise is detected, the microwave is heating. With no power at all, check the breaker or fuse.
Microwave repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.

