Inside the appliance
Microwave relay control board. In plain English.
The relay control board switches the microwave’s functions. JennAir’s F1E1 page for over-the-range microwaves says the oven could not execute the function and names the relay control board or its wiring as the possible problem.

Where it fits.
Microwave relay control board in the appliance
The page names the board and its wiring but gives no position. They are inside the cabinet.
The picture shows the kind of component only. It cannot tell you which replacement suits your model.
What you notice when this system needs a look.
A Microwave relay control board concern may show up with a drop in performance or a code that keeps returning. Testing comes first, before anyone decides the component is to blame.

JennAir built-in microwave not heating
First confirm the controls: enter Cook Time, then Cook Power if it is not 100%, and press Start. Then test with one cup of water for one minute on HI. If heat rise is detected, the microwave is heating. With no power at all, check the breaker or fuse.

JennAir built-in microwave will not start
A microwave that has power but will not start is usually blocked by the door, the Control Lock, Demo Mode or a blank Energy Save display. Confirm that nothing stops the door shutting, check the lock, then switch the breaker off for a minute.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Power down
Leave the breaker off for a minute, then switch it back on.
- 2
Watch for a minute
Monitor the microwave for one minute to see if the code returns.
- 3
Test it
Run the microwave and check it works as it should.
- 4
Note the code
The page covers F1E1 only. Other codes mean other things.
Cleaning or replacement?
Leave internal testing to a technician.
Book us if F1E1 returns after the reset. The board and wiring sit inside the microwave.
Arrange a diagnosticSources and model boundaries.
The Microwave relay control board guidance rests on these references. Pick the manual that fits your model.
- F1E1 - Error Code - Over-the-Range Microwave - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
What does F1E1 mean?
The oven could not execute the function. JennAir names the relay control board or its wiring.
Can a reset fix it?
JennAir lists a one-minute breaker reset first.
Is this for built-ins too?
The page is for over-the-range microwaves.
Can I replace the board?
The page gives no replacement steps. Book a technician.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir built-in microwave not heating
First confirm the controls: enter Cook Time, then Cook Power if it is not 100%, and press Start. Then test with one cup of water for one minute on HI. If heat rise is detected, the microwave is heating. With no power at all, check the breaker or fuse.
Microwave repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.

