Inside the appliance
Gas oven igniter. In plain English.
The igniter in a JennAir gas oven clicks repeatedly until a flame registers. JennAir calls that short tapping sound normal. When the oven stays cold but the cooktop works, its help pages begin with the door, the gas shut-off valve on the regulator, the storage drawer and any foil on the oven bottom.

Where it fits.
Gas oven igniter in the appliance
JennAir's pages give no word on where the igniter sits; the shut-off valve is on the range's pressure regulator.
The picture shows the kind of component only. It cannot tell you which replacement suits your model.
What you notice when this system needs a look.
A Gas oven igniter concern may show up with a drop in performance or a code that keeps returning. Testing comes first, before anyone decides the component is to blame.

JennAir oven temperature problems
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.

JennAir range burner problems
Find your cooktop type first. Glowing that cycles on and off is normal on electric coil and glass tops, and gas flame trouble starts with clean ports and a seated cap. LP conversion or a wrong gas type needs a technician.
Owner care, within the model instructions.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Listen for the click
JennAir describes brief tapping clicks, similar to a nail on glass, that repeat until a flame registers. It calls them normal.
- 2
Close the oven door
On some models the elements stay off while the door is open.
- 3
Check the shut-off valve
A gas range has a shut-off valve on its pressure regulator. If it is off, gas reaches the cooktop burners but not the oven. A stored utensil can nudge its lever.
- 4
Empty the storage drawer
JennAir says an overloaded drawer, with pots, pans or extra racks, may interfere with the igniter. Take some items out.
- 5
Uncover the oven bottom
Do not cover the bottom with foil or a liner. It can block air or gas flow to the burner.
Cleaning or replacement?
Leave internal testing to a technician.
The igniter keeps clicking and the oven never lights.
You are unsure the shut-off valve is open.
Gas odor: get everyone out and phone your gas company before anything else.
Arrange a diagnosticSources and model boundaries.
The Gas oven igniter guidance rests on these references. Pick the manual that fits your model.
- Clicking Noise in a Gas Oven - Product Help | JennAir
- Oven Not Working - Cooktop Working - Clicking - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
Is the clicking in my gas oven normal?
JennAir says brief tapping clicks, similar to a nail on glass, are normal. They repeat until a flame registers.
Cooktop burns, oven stays cold. Why?
JennAir starts with a closed door, the regulator valve set to OFF, a crowded storage drawer and foil on the oven bottom.
Where is the gas shut-off valve?
On the pressure regulator of a gas range, separate from the home supply line. JennAir says it can be bumped to OFF in transport or by a utensil in the drawer.
Can I line the oven bottom with foil?
No. JennAir says foil or a bottom liner can block air or gas flow to the burner.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir oven temperature problems
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Oven repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.

