Start from the symptom
JennAir dishwasher noisy.
Many JennAir dishwasher sounds are normal: rushing water, swishing, humming and a drying fan that runs for hours. Grinding, thumping and squeaking each have a simple first check before you book a visit.

Start with safe observations.
Turn the appliance off and unplug it before any check you can do yourself. Look out for pooled water and sharp edges. Never touch a wet plug or live area, take off service panels, or go past your model’s owner instructions.
- 1
Rushing and swishing
Both are normal while the tub fills and the arms spray. A unit at the end of a cabinet row can sound louder than one between cabinets.
- 2
Fan hum
After a cycle a fan may run up to 8 hours or until the door opens, depending on cycle and model.
- 3
Grinding
Look in the filter area for stuck objects and clean the filter.
- 4
Thumping
An item extending beyond the rack can strike the spray arms. Reposition it and resume.
- 5
Squeaking
Check the door is not rubbing the cabinet and the dishwasher is level and square in its opening.
Systems a technician may investigate.
The symptom connects to these parts. What you observed cannot show that any single one has failed.
If the display adds a code.
No code tied directly to this topic.
No further researched dishwasher code is attached to this topic. Compare your exact message with your model manual and do not stand in a different code from the library.
See the research statusRead the related care guide.

New dishwasher full of water? Check the install.
A newly installed JennAir dishwasher that will not drain usually has a setup problem: the disposer knockout plug is still in, the hose is kinked, or the drain loop or air gap is missing. Check those before you suspect the pump. Power the dishwasher off before you touch the hose. [1][2]

Drips under the counter? Steam or a leak.
Moisture on the underside of the counter near a JennAir dishwasher is usually condensation: steam from the vent meeting a cooler surface. A leak looks different, with water at the door edge, on the floor or under the unit. Check where the water shows up, and when. [1][2]
When observation becomes a service request.
Leave internal testing to a technician.
The noise continues after the load and filter checks, or it is a loud metallic grinding. Stop the cycle and book a visit.
Arrange a diagnosticSources and model boundaries.
The JennAir dishwasher noisy guidance rests on these references. Pick the manual that fits your model.
- Normal Dishwasher Sounds and Noise - Product Help | JennAir
- Fan Noise - Dishwasher - Product Help | JennAir
- Grinding - Dishwasher - Product Help | JennAir
- Rushing Water - Dishwasher - Product Help | JennAir
- Squeaking - Dishwasher - Product Help | JennAir
- Swishing - Dishwasher - Product Help | JennAir
- Thumping - Dishwasher - Product Help | JennAir
Go by the instructions for your own model. See how we research these pages.
Is a fan running after the cycle normal?
Yes. JennAir says the fan may run up to 8 hours, or until the door is opened, to dry dishes and remove heat.
What causes grinding in a dishwasher?
JennAir points to something caught in the filter area, so check and clean the filter first.
Why do I hear thumping?
Items sticking out of the racks can hit the spray arms. Rearrange them and restart the cycle.
Why does the door squeak when I open it?
The door may be rubbing a cabinet, or the dishwasher may not be level or square in its opening.
Code or symptom, part, service call
Tie the message to what comes next.
JennAir dishwasher won't start or fill
JennAir's order is power, then the door and lower rack, then water supply, control lock, delay start, and a one-minute reset. A dishwasher that will not fill adds the drain loop height and an interrupted-cycle flash to the list.
Dishwasher removable filter
JennAir dishwashers with a removable filter ask you to clean it by hand under running water, with a soft brush for hard-water deposits. Abrasive pads and wire brushes are out, and the dishwasher should not operate without both filters in place.
Dishwasher repair
Schedule a diagnostic for your model, carried out at the appliance.
Find your metro
Office details, plus the access notes to pass along.
