What it means
FILL TANK! means the water tank is empty or incorrectly positioned. Fill it with water or push it in as far as it will go. JennAir also says the tank has to be clean so the float can move freely.
JennAir coffee machine FILL TANK! / Water and tank
FILL TANK! means the water tank is empty or incorrectly positioned. Fill it with water or push it in as far as it will go. JennAir also says the tank has to be clean so the float can move freely.
Also shown as FILL TANK!
FILL TANK! means the water tank is empty or incorrectly positioned. Fill it with water or push it in as far as it will go. JennAir also says the tank has to be clean so the float can move freely.
If the tank is low, fill it with water.
FILL TANK! stays with a full, clean, seated tank.
Checks you have ticked / saved in this browser

If the tank is low, fill it with water.

JennAir says to insert it correctly, pushing it all the way in.

The page says the tank must be cleaned to allow free motion of the float. A sticking float can read empty.
The prompt should clear once the machine senses water.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit


A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
Mineral scale builds up inside the coffee maker’s thermoblock and lines.
Read the definitionThe water tank is empty or incorrectly positioned.
Read the supporting manualFill the tank and insert it correctly, pushing it in as far as it will go.
Read the supporting manualJennAir says the tank needs cleaning so the float moves freely. A float stuck by deposits reports low water.
Read the supporting manualWhen a clean, full, correctly seated tank still prompts, the level sensing is the next thing to check.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-03-19; PH 2750 / PH 2750 (built-in coffee maker)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2026-11-06; PH 10313 / PH 10313 (built-in coffee maker, display messages)
Scope: JennAir built-in coffee maker. Read from the JennAir Product Help message page for this code and checked against the overview page of display messages (November 2026).
Either it is not pushed fully in, or the float is stuck. JennAir says to seat it properly and clean it so the float can move.
It is the part in the tank that rises with the water level. The page says it needs to move freely.
Remove it and clean it as the tank cleaning guidance describes.
No water means no brewing and nothing harmful, but do not run it dry deliberately. Fill the tank before using it.
Code or symptom, part, service call
DESCALE! tells you the brewer needs its descaling program, and JennAir says to run it as soon as possible. It is a maintenance reminder, not a failure. If the cycle is interrupted it has to start again from the beginning.
A display prompt halts brewing until you fix the condition: refill and seat the tank for FILL TANK, empty the grounds container, reseat the brewing unit, close the service door, or adjust a too-fine grind. DESCALE needs the descaling cycle. GENERAL ALARM means clean the inside.
Mineral scale builds up inside the coffee maker’s thermoblock and lines. JennAir’s DESCALE! prompt starts a menu cycle with a commercial descaler, never vinegar. The water tank is filled to MAX before and after, and water hardness is set from a test strip.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.