Read the whole display
Quote the exact words on the screen, including the exclamation mark, and say what you last did to the unit.
Model-specific code library
Thirteen display messages are decoded for the built-in coffee maker, among them FILL TANK!, DESCALE!, INSERT BREWING UNIT and GENERAL ALARM. Most ask you to refill, empty or reseat something.
ADD GROUND COFFEE appears when the ground coffee function is selected but the funnel holds no coffee. Slide the coffee system out, add ground coffee through the funnel with the supplied scoop, and start the drink again.
Read the ADD GROUND COFFEE checks13 researched coffee machine codes. Each model reads codes its own way, so go by your own manual.
ADD GROUND COFFEE appears when the ground coffee function is selected but the funnel holds no coffee. Slide the coffee system out, add ground coffee through the funnel with the supplied scoop, and start the drink again.
Owner checks firstCLOSE DOOR! means the service door on the front of the coffee system is open. Close it fully; if the message stays, check that the drip tray and brewing unit are pushed all the way back.
Owner checks firstDESCALE! tells you the brewer needs its descaling program, and JennAir says to run it as soon as possible. It is a maintenance reminder, not a failure. If the cycle is interrupted it has to start again from the beginning.
Maintenance dueEMPTY GROUNDS CONTAINER means the container is full and has to be emptied and cleaned. Switch the coffee system off with On/Standby, take out the cup tray and grounds container, empty it and wipe out the residue.
Owner checks firstFILL BEANS CONTAINER! means the coffee beans have run out. Use the handles to slide the coffee system forward, fill the bean container, and push the system back into the housing.
Owner checks firstFILL TANK! means the water tank is empty or incorrectly positioned. Fill it with water or push it in as far as it will go. JennAir also says the tank has to be clean so the float can move freely.
Owner checks firstGENERAL ALARM means the inside of the coffee system needs to be cleaned. JennAir says to clean the inside thoroughly; if the message still shows after cleaning, service is needed.
Clean, then bookGROUND TOO FINE ADJUST MILL means the grind is so fine that the coffee runs off too slowly. Check the tank is seated, turn the grinding adjustment knob one click toward number 7 while the grinder runs, then press OK.
Owner checks firstINSERT BREWING UNIT means the brewing unit has not been put back after cleaning. Switch the coffee system off, take out the tray and grounds container, and push the unit in until it clicks and both red buttons spring out.
Owner checks firstINSERT GROUNDS CONTAINER means the grounds container was not put back after cleaning. Open the service door and insert it, making sure it sits correctly on the drip tray.
Owner checks firstINSERT MILK CONTAINER! means the milk container is missing or incorrectly positioned. Insert it correctly, pushing it in as far as it will go.
Owner checks firstPRESS CLEAN BUTTON is the prompt that starts frother cleaning. Put a container under the milk spout and hold CLEAN on the milk container lid for at least 8 seconds; do not release until the progress bar finishes.
Routine cleaningSELF DIAGNOSIS is not a failure. The coffee system shows it each time the main power button is switched on, then runs a self-test, preheat and rinse that cannot be interrupted. Press On/Standby once afterwards to wake it.
Information only
Thirteen display messages are decoded for the built-in coffee maker, among them FILL TANK!, DESCALE!, INSERT BREWING UNIT and GENERAL ALARM. Most ask you to refill, empty or reseat something.
These are Product Help pages for the built-in coffee maker. Freestanding JennAir coffee products are not covered.
Quote the exact words on the screen, including the exclamation mark, and say what you last did to the unit.
Switch it off and let it cool before you reach into the brew area. GENERAL ALARM and SELF DIAGNOSIS need a technician.
A display prompt halts brewing until you fix the condition: refill and seat the tank for FILL TANK, empty the grounds container, reseat the brewing unit, close the service door, or adjust a too-fine grind. DESCALE needs the descaling cycle. GENERAL ALARM means clean the inside.
JennAir ties most coffee problems to cold cups, grind fineness, spouts or scale. Cold coffee: pre-warm cups and run a rinse. Weak coffee: grind one click finer. Slow, drop-by-drop coffee: grind one click coarser, clear the spouts and descale.
Go by the instructions for your own model. See how we research these pages.
These are Product Help pages for the built-in coffee maker. Freestanding JennAir coffee products are not covered.
Take a clear photo of the whole coffee-machine display and of the model label. Add what the appliance was doing when the message came up, and do not borrow the explanation for a different appliance.
An old search phrase is no substitute for manufacturer evidence. When our coffee-machine documents leave a message undecoded, we show the name only and send you toward help, with no part or cause attached.
Browse the manufacturer documents in this coffee-machine library and hold the models on their covers up against your label. Another model needs instructions of its own.