What it means
F0E1 on a JennAir induction cooktop asks whether the cookware is right. Only ferromagnetic pans work, and the pot must be a suitable size and centered. Press On/Off twice to clear the code, then try another zone or pan.
JennAir cooktop F0E1 / Cookware detection
F0E1 on a JennAir induction cooktop asks whether the cookware is right. Only ferromagnetic pans work, and the pot must be a suitable size and centered. Press On/Off twice to clear the code, then try another zone or pan.
Also shown as F0E1
F0E1 on a JennAir induction cooktop asks whether the cookware is right. Only ferromagnetic pans work, and the pot must be a suitable size and centered. Press On/Off twice to clear the code, then try another zone or pan.
Pans stay hot after the code clears, so lift them with care and keep the glass free of other items.
F0E1 returns with a magnetic, centered pan that worked before.
Checks you have ticked / saved in this browser

JennAir lists enameled steel, cast iron and stainless steel designed for induction cooking. A magnet should stick to a suitable pot.

Some pans have only part of the base in magnetic material, so the cooktop may not detect them.

Use a pot of suitable minimum diameter, centered on the zone that best matches its base, and not larger than the zone.

This removes the code and restores the zone. Then try a different zone or pan.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
JennAir frames it as a cookware question: is the right pan in use, and is it the right size?
Read the supporting manualPots made from ferromagnetic material suitable for induction: enameled steel, cast iron, and stainless designed for induction.
Read the supporting manualUse a pot of suitable minimum diameter, centered, on the zone that best fits its base. Avoid pots that exceed the zone.
Read the supporting manualPress On/Off twice to remove the code and restore the zone, then try a different zone or pan.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-04-07; PH 12426 / PH 12426 (induction cooktop)
Scope: JennAir induction cooktop. Read from the JennAir Product Help page for F0E1 (PH 12426).
JennAir says the pan may be non-ferromagnetic, too small, off-center, or only partly magnetic at the base.
Hold a magnet to the base. JennAir suggests a magnet to check whether a pot is magnetic.
Only stainless designed for induction. JennAir also lists plain stainless among the non-ferromagnetic materials, with glass, ceramic, copper and aluminum.
Press On/Off twice, then use different cookware or another cooking zone.
Code or symptom, part, service call
E2 on a JennAir induction cooktop means the cooktop has overheated. The control panel switches off because the electronics reached too high a temperature. Wait for the cooktop to cool before using it, and check you were not heating an empty pan.
Clicking with no flame points to a short list: Control Lockout after a power loss, a closed gas shut-off, a knob not turned to Ignite, moisture, or clogged ports. On a first start JennAir says to turn one knob for a moment so air leaves the line.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.