What it means
A blinking Clean light means the cleaning cycle is in progress, or it was interrupted. Press Clean to resume. When the Cleaning Complete light comes on, about 70 to 90 minutes later, the cycle is finished.
JennAir ice maker Clean light blinking / Mode, not a failure
A blinking Clean light means the cleaning cycle is in progress, or it was interrupted. Press Clean to resume. When the Cleaning Complete light comes on, about 70 to 90 minutes later, the cycle is finished.
Also shown as Clean light blinking
A blinking Clean light means the cleaning cycle is in progress, or it was interrupted. Press Clean to resume. When the Cleaning Complete light comes on, about 70 to 90 minutes later, the cycle is finished.
If the light keeps blinking after a stop, press Clean to resume.
The Clean light still blinks after a full cycle and a restart.
Checks you have ticked / saved in this browser

If the light keeps blinking after a stop, press Clean to resume.

About 70 to 90 minutes.

If it still blinks, unplug it or turn power off at the fuse or breaker, then restore power.

If the indicator stays on after the restart, press Clean so the cycle can complete.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
The clean cycle is running, or it was interrupted and needs a press of Clean to resume.
Read the supporting manualPress Clean to resume if it was interrupted, then wait for the Cleaning Complete light, about 70 to 90 minutes.
Read the supporting manualRestart the ice maker by unplugging it or cutting power at the fuse or breaker, then press Clean so the cycle can complete.
Read the supporting manualMinerals frozen out of the water leave a hard scale that hinders the ice maker.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-04-09; PH 10151 / PH 10151 (freestanding ice maker)
Scope: JennAir freestanding ice maker. Read from the JennAir Product Help page for the blinking cleaning light (PH 10151).
When the Cleaning Needed or Cleaning Cycle button is lit, after 9 months, or when ice production falls noticeably. Hard water can mean every 6 months.
About 70 to 90 minutes, ending with Cleaning Complete.
Minerals from the water form a hard scale in the water system, and cleaning removes it.
Restart the ice maker as above. If it is still stuck, book a visit.
Code or symptom, part, service call
A lit Service light tells you the ice maker needs service. Power it down and up a single time with its on/off control; if the light is back afterward, a technician has to look at it.
When a freestanding ice maker goes quiet, look for a dirty or blocked bin sensor, a cracked or badly locked water filter, or a cleaning cycle that was cut short. Check those, level the unit and restart it. A service light that returns means a repair.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.