What it means
1c2c says the touch controls or the wiring may need attention. Cycle the breaker once, a minute off; if the code returns, schedule a visit.
JennAir oven 1c2c / User interface
1c2c says the touch controls or the wiring may need attention. Cycle the breaker once, a minute off; if the code returns, schedule a visit.
Also shown as 1c2c
1c2c says the touch controls or the wiring may need attention. Cycle the breaker once, a minute off; if the code returns, schedule a visit.
Leave panels on while 1c2c shows; household power sits behind them.
1c2c returns after the breaker reset.
Checks you have ticked / saved in this browser

Leave panels on while 1c2c shows; household power sits behind them.

Use the breaker, not the oven keys; after a minute, watch for 1c2c again.

Cycle, setting and time when 1c2c first appeared save a technician time.

Test each key in turn after the reset; a dead zone goes in your notes.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit
A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
The user interface is the keypad or touch panel you press.
Read the definitionFor 1c2c, the page blames the keypad or connected wiring. Testing has to pick.
Read the supporting manualJennAir's fix for 1c2c is a breaker reset for one minute. Then watch for a minute.
Read the supporting manualOur view, not JennAir's: use it only while it behaves normally. Burning smells or sparks mean switch off plus a visit.
Read the supporting manualOn the 1c31 row JennAir lists the electronic control; 1c2c lists the keypad (user interface).
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-08-16; PH 12888 / PH 12888 (range)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13262 / PH 13262 (wall oven)
Product lines: freestanding range and wall oven. Cited: JennAir Product Help PH 12888, PH 13262. One printed line for 1c2c, so our guidance is general.
The page names the touch controls or its wiring as possible trouble spots for 1c2c.
Cut the breaker for 60 seconds, then on, then monitor 1c2c a minute.
Hold off while 1c2c is up. Reset first, then short bakes are fine.
Not on its own. JennAir gives 1c2c suspects, not a diagnosis.
Code or symptom, part, service call
1c31 names the oven's control board or the wiring serving it on JennAir ranges and wall ovens. The first step is a sixty-second power reset at the breaker panel; call for service if it returns.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
The user interface is the keypad or touch panel you press. JennAir lists it in the F2 family (F2 E0 to F2 E6), where F2 E1 often means a key is stuck or held too long. The help pages suggest checking cooktop grates on some ranges, then a one-minute reset.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.