What it means
Read 3d12 as a warning about the temperature sensor and/or the main control, wiring second. Try a one-minute breaker reset, then look for the code for a minute.
JennAir oven 3d12 / Temperature sensor
Read 3d12 as a warning about the temperature sensor and/or the main control, wiring second. Try a one-minute breaker reset, then look for the code for a minute.
Also shown as 3d12
Read 3d12 as a warning about the temperature sensor and/or the main control, wiring second. Try a one-minute breaker reset, then look for the code for a minute.
Wait for racks and door glass to cool while 3d12 is on.
3d12 returns after the breaker reset.
Checks you have ticked / saved in this browser

Wait for racks and door glass to cool while 3d12 is on.

Use the breaker panel, not the oven; after 60 seconds, watch for 3d12 again.

Time, setting and cycle when 3d12 first appeared save a technician time.

The sensor is a slim rod at the rear of the cavity; do not lean trays on it while 3d12 is a question.
Send the model and the checks you have already run, then begin your request from this page.
Book a visitA simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
JennAir Product Help ties F1, F2 and several F3 codes to the oven temperature sensor, the control or the wiring between them.
Read the definition
Component reference
The electronic control is the board that manages the oven functions.
Read the definitionJennAir lists the oven sensor and/or the main control as the suspect for 3d12. It narrows nothing further.
Read the supporting manualJennAir's fix for 3d12 is a breaker reset for 60 seconds. Then a minute of watching.
Read the supporting manualOnce it behaves after the reset, short bakes are reasonable. A second 3d12 means stand down and schedule a visit.
Read the supporting manualJennAir prints the same suspects for 3d21: the cavity sensor or the electronic control. Numbers alone do not separate 3d12 from it.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-08-16; PH 12902 / PH 12902 (range)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13276 / PH 13276 (wall oven)
Scope: freestanding range and wall oven. Taken from JennAir Product Help, PH 12902, PH 13276. Neighbors of 3d12 use similar wording.
The help page lists the sensing probe or the electronic control or the wiring as suspects for 3d12.
Breaker off for a minute, then on, then watch 3d12 for 60 seconds.
Hold off while 3d12 is up. Reset, then judge, then short bakes are fine.
Not by itself. The page for 3d12 names suspects only.
Code or symptom, part, service call
Read 3d21 as a flag on the cavity sensor or the main control, wiring second. Try a minute-long power cycle, then watch the code for 60 seconds.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
JennAir Product Help ties F1, F2 and several F3 codes to the oven temperature sensor, the control or the wiring between them. The sensor reports cavity heat to the control. The help pages pair it with the control, so one reset is the only owner step.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.