What it means
Read 3d21 as a flag on the cavity sensor or the main control, wiring second. Try a minute-long power cycle, then watch the code for 60 seconds.
JennAir oven 3d21 / Temperature sensor
Read 3d21 as a flag on the cavity sensor or the main control, wiring second. Try a minute-long power cycle, then watch the code for 60 seconds.
Also shown as 3d21
Read 3d21 as a flag on the cavity sensor or the main control, wiring second. Try a minute-long power cycle, then watch the code for 60 seconds.
Leave panels on while 3d21 shows; the wiring is live.
3d21 returns after the breaker reset.
Checks you have ticked / saved in this browser

Leave panels on while 3d21 shows; the wiring is live.

Breaker off for a solid minute, then on; watch for 3d21 one more minute.

Jot down 3d21 as displayed, and the cycle running at that moment.

An oven thermometer placed center offers a cross-check during a 3d21 problem.
Send the model and the checks you have already run, then begin your request from this page.
Book a visitA simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.

Component reference
JennAir Product Help ties F1, F2 and several F3 codes to the oven temperature sensor, the control or the wiring between them.
Read the definition
Component reference
The electronic control is the board that manages the oven functions.
Read the definitionFor 3d21, JennAir suggests the sensing probe and/or the main control or connected wiring. Testing has to pick.
Read the supporting manualThe page's fix for 3d21 is a breaker reset for 60 seconds. Then watch for a minute.
Read the supporting manualThat is our judgment, not JennAir's: cook only while it behaves. A tripped breaker or smoke mean switch off plus a technician.
Read the supporting manualJennAir gives the same suspects for 3d22: the oven sensor and/or the oven control. Numbers alone do not separate 3d21 from it.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-08-16; PH 12903 / PH 12903 (range)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13277 / PH 13277 (wall oven)
Applies to: freestanding range and wall oven. Cited: JennAir Product Help PH 12903, PH 13277. One printed line for 3d21, so our guidance is general.
JennAir lists the sensing probe and/or the control or connected wiring as suspects for 3d21.
Breaker off for a minute, then back on, then monitor 3d21 for 60 seconds.
Better not with 3d21 showing. Reset, then judge, then cook if it heats normally.
Not on its own. JennAir lists suspects for 3d21, not a verdict.
Code or symptom, part, service call
3d22 lists the temperature sensor and the control, or the wiring between them. The first step is a sixty-second power reset at the breaker panel; call for service if it returns.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
JennAir Product Help ties F1, F2 and several F3 codes to the oven temperature sensor, the control or the wiring between them. The sensor reports cavity heat to the control. The help pages pair it with the control, so one reset is the only owner step.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.