What it means
F4 E9 is the third inverter row on JennAir wall ovens, worded like F4 E0 and E8: the microwave inverter or its wiring. Reset the breaker for a single minute and keep the microwave off if the code returns.
JennAir oven F4E9 / Microwave (combination oven)
F4 E9 is the third inverter row on JennAir wall ovens, worded like F4 E0 and E8: the microwave inverter or its wiring. Reset the breaker for a single minute and keep the microwave off if the code returns.
Also shown as F4E9
F4 E9 is the third inverter row on JennAir wall ovens, worded like F4 E0 and E8: the microwave inverter or its wiring. Reset the breaker for a single minute and keep the microwave off if the code returns.
Clear everything out before testing.
F4 E9 returns after the reset.
Checks you have ticked / saved in this browser

Clear everything out before testing.

Restore power afterward.

A cup of water for a short run.

Do not retry more than once.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
It closes the F4 E list for wall ovens, after the humidity, weight and wave guide sensors and the probe.
Read the supporting manualThe microwave inverter or the wiring. The inverter controls how the magnetron receives power.
Read the supporting manualJennAir prints it as its own page but words it identically. The reason for two numbers is not given.
Read the supporting manualReset once. If the code returns, set the microwave aside and book a visit.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13355 / PH 13355 (wall oven)
PH 13355: F4E9, wall-oven.
It means JennAir lists it as a possible trouble spot, nothing firmer.
JennAir does not explain them.
Probably, but test with a normal bake.
Book a technician; microwave circuits are not for DIY.
Code or symptom, part, service call
Plain F4 is printed for wall ovens only: JennAir points at the oven cavity control or the wiring that serves it. Power the oven down at its breaker for about a minute, bring it back, and see whether F4 stays away for the next minute.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.