What it means
F8 E5 repeats the exhaust fan air temperature sensor wording of E4 on a JennAir wall oven. Clear the exhaust path, reset the breaker for about a minute, and run a short test bake.
JennAir oven F8E5 / Cooling fan
F8 E5 repeats the exhaust fan air temperature sensor wording of E4 on a JennAir wall oven. Clear the exhaust path, reset the breaker for about a minute, and run a short test bake.
Also shown as F8E5
F8 E5 repeats the exhaust fan air temperature sensor wording of E4 on a JennAir wall oven. Clear the exhaust path, reset the breaker for about a minute, and run a short test bake.
Let it rest with the door closed.
F8 E5 returns after the reset.
Checks you have ticked / saved in this browser

Let it rest with the door closed.

Anything stacked near the oven can restrict airflow.

Restore and wait.

See whether the code returns at the same stage as before.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
The exhaust fan air temperature sensor or the associated wiring, word for word as in E4.
Read the supporting manualThe page does not say. The digits may mark different circuits or conditions that Product Help does not describe, so we make no claim about them.
Read the supporting manualVery little. The sensor sits in the exhaust path and the page offers no owner steps beyond power cycling.
Read the supporting manualIf E5 comes back, especially if E4 appears too. Two sensor messages together suggest looking at the wiring or the control.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13388 / PH 13388 (wall oven)
PH 13388: F8E5, wall-oven.
The wording is identical. Treat them alike.
Possible. Report both to the technician.
On a combination oven, F4 E3 is the microwave-side code. E5 is about the oven exhaust.
Short, attended bakes are a cautious option. Do not run self-clean.
Code or symptom, part, service call
F8 EA names the user interface or its wiring on a JennAir freestanding range. Press CANCEL, reset the breaker for sixty seconds, then test the keys one at a time.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.