What it means
FEE8 is a reset-only message on a JennAir freestanding range; the page names no part. Cycle the breaker for a single minute, restore power and monitor the oven for a minute.
JennAir oven FEE8 / Reset only
FEE8 is a reset-only message on a JennAir freestanding range; the page names no part. Cycle the breaker for a single minute, restore power and monitor the oven for a minute.
Also shown as FEE8
FEE8 is a reset-only message on a JennAir freestanding range; the page names no part. Cycle the breaker for a single minute, restore power and monitor the oven for a minute.
Close the door and avoid starting a cycle during the reset.
FEE8 returns after the reset.
Checks you have ticked / saved in this browser

Close the door and avoid starting a cycle during the reset.

Restore power.

One minute.

Check for normal heating.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
Only the reset steps. The page contains no cause or part, unlike FEE6 and FEE7, which name elements.
Read the supporting manualIts neighbors suggest the FEE series concerns the heating circuit, but the page for FEE8 says nothing, so we will not claim it.
Read the supporting manualThe time of day, the cycle you were running and whether the oven was preheating.
Read the supporting manualIf FEE8 returns after the reset.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-03-17; PH 13672 / PH 13672 (range)
PH 13672: FEE8, range.
They share reset-only wording but are separate pages.
If the code clears and the oven heats, yes, with attention.
The page names none.
The printed reset is the breaker.
Code or symptom, part, service call
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.