What it means
A flashing time, 12:00, POWER LOSS or Enter Time on a JennAir range or wall oven means power was interrupted. Press CANCEL to clear the display, then set the clock.
JennAir oven Flashing Time or POWER LOSS / Display message
A flashing time, 12:00, POWER LOSS or Enter Time on a JennAir range or wall oven means power was interrupted. Press CANCEL to clear the display, then set the clock.
Also shown as Flashing Time or POWER LOSS
A flashing time, 12:00, POWER LOSS or Enter Time on a JennAir range or wall oven means power was interrupted. Press CANCEL to clear the display, then set the clock.
Clear the display first.
The clock flashes again with no outage.
Checks you have ticked / saved in this browser

Clear the display first.

Follow your control's clock steps.

If power failed because a breaker tripped, reset it once.

A house-wide outage explains it at once.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
Power was lost, even for a moment. The oven forgets the time and flashes to ask for it.
Read the supporting manualNo. JennAir lists it as a normal response to a power interruption, not an error.
Read the supporting manualFrequent flashes suggest unstable power at the home. Unplugging other heavy loads when the oven runs may help, but check with an electrician.
Read the supporting manualIf the clock flashes repeatedly with no outage.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-04-14; PH 13130 / PH 13130 (range)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-08; PH 13254 / PH 13254 (wall oven)
PH 13130, 13254: FLASHING-TIME-OR-POWER-LOSS, range/wall-oven.
Time of day, yes. Cook programs stop.
PF is also a power failure message on some displays.
Same event, different display.
The oven may still bake, but it can refuse timed features.
Code or symptom, part, service call
PF on a JennAir wall oven means there has been a power failure. Press CANCEL to clear it and reset the clock if asked; if PF keeps coming back, check the supply, because line noise or early key presses can also cause it.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.