What it means
PF on a JennAir wall oven means there has been a power failure. Press CANCEL to clear it and reset the clock if asked; if PF keeps coming back, check the supply, because line noise or early key presses can also cause it.
JennAir oven PF / Power failure
PF on a JennAir wall oven means there has been a power failure. Press CANCEL to clear it and reset the clock if asked; if PF keeps coming back, check the supply, because line noise or early key presses can also cause it.
Also shown as PF
PF on a JennAir wall oven means there has been a power failure. Press CANCEL to clear it and reset the clock if asked; if PF keeps coming back, check the supply, because line noise or early key presses can also cause it.
The Error Codes chart says this clears the display.
PF repeats without a power outage.
Checks you have ticked / saved in this browser

The Error Codes chart says this clears the display.

Some models need the time set again.

Key presses in the first ten seconds can show PF, F9 or F9 E0.

Then monitor for a minute and test a bake.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
JennAir's Error Codes for Cooking Appliances page lists PF as a power failure, to be cleared by pressing the cancel pad, with the clock set again on some models.
Read the supporting manualIt says that during an outage, unexpected line noise that the control reads as a wrong voltage can show F9, F9 E0 or PF. Keys pressed before the ten-second delay after power-up can do the same.
Read the supporting manualIf it appears with no outage and with F9, the supply wiring at the home may be wrong. That reading comes from the F9 page, so see it.
Read the supporting manualIf PF repeats on a stable supply.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-10-16; PH 686 / PH 686 (wall oven)
Manufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-11-13; PH 13389 / PH 13389 (wall oven)
PH 686, 13389: PF, wall-oven/general cooking appliance chart.
The wall oven page lists them together as possible results of supply noise.
Yes, an outage stops a cycle.
Only if PF repeats without an outage.
Not discussed in the pages.
Code or symptom, part, service call
F9 on a JennAir wall oven most often means the oven was wired wrongly at the home supply or the hard-wire connection, with L2 and N swapped as the example; a steam oven page gives only a reset. Call an electrician before using the oven again.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.