What it means
Lo on a JennAir freestanding range's display after you start the oven is a status, not an error: it says the oven is below 170 degrees F. Give it time to warm; the reading becomes a number as the oven heats.
JennAir oven Lo / Display message
Lo on a JennAir freestanding range's display after you start the oven is a status, not an error: it says the oven is below 170 degrees F. Give it time to warm; the reading becomes a number as the oven heats.
Also shown as Lo
Lo on a JennAir freestanding range's display after you start the oven is a status, not an error: it says the oven is below 170 degrees F. Give it time to warm; the reading becomes a number as the oven heats.
Lo clears itself once the cavity passes the threshold.
Lo stays on and the oven never warms up.
Checks you have ticked / saved in this browser

Lo clears itself once the cavity passes the threshold.

Opening it lets heat out and stretches the wait.

Pre means preheating; Lo means the oven is still below 170 degrees F.

If you chose a very low bake, Lo may linger.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
No. JennAir lists it on its Lo or Pre page as a display status for a range. It tells you the oven has not reached 170 degrees F yet.
Read the supporting manualPre says the oven is preheating toward your set temperature. Lo says the temperature is below 170 degrees F. They appear on the same JennAir page for a reason: both are part of normal warm-up.
Read the supporting manualIf the oven is set for a low temperature, or if heat is not building. A long Lo with no heat in the cavity is the time to check the breaker and book.
Read the supporting manualNo. This is not a code to clear.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-07; PH 13127 / PH 13127 (range)
PH 13127: LO, range.
It means below 170 degrees F, so it may be warm but not hot.
JennAir gives no time. It depends on the set temperature and the oven.
No. PF is a power failure message.
Only if the oven never warms or the reading never changes.
Code or symptom, part, service call
Pre on a JennAir freestanding range's display after you start the oven is a status, not an error: the oven is preheating. The display moves to a number as the cavity warms; wait for the signal that preheat is done.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.