What it means
Pre on a JennAir freestanding range's display after you start the oven is a status, not an error: the oven is preheating. The display moves to a number as the cavity warms; wait for the signal that preheat is done.
JennAir oven Pre / Display message
Pre on a JennAir freestanding range's display after you start the oven is a status, not an error: the oven is preheating. The display moves to a number as the cavity warms; wait for the signal that preheat is done.
Also shown as Pre
Pre on a JennAir freestanding range's display after you start the oven is a status, not an error: the oven is preheating. The display moves to a number as the cavity warms; wait for the signal that preheat is done.
Do not load food until the preheat signal sounds or Pre disappears.
Pre never changes and the oven stays cold.
Checks you have ticked / saved in this browser

Do not load food until the preheat signal sounds or Pre disappears.

Opening it resets progress and wastes energy.

Pre is replaced by a number as heat rises.

If you see Lo instead, the oven is below 170 degrees F.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit

A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
That the oven is working toward the temperature you chose. JennAir lists Pre next to Lo on its range page as a normal display message.
Read the supporting manualPre is about the process, preheating. Lo is about a reading, below 170 degrees F. You may see one, the other or both in sequence.
Read the supporting manualUse the setting you need rather than a higher one. A higher setting does not make the cavity heat faster, and it can overshoot.
Read the supporting manualIf Pre never changes after many minutes, or the oven stays cold, check the breaker and book a visit.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2024-11-07; PH 13127 / PH 13127 (range)
PH 13127: PRE, range.
No.
Wait for the preheat to finish for baking.
A large cavity or a high setting takes longer. JennAir gives no times.
JennAir's page here covers freestanding ranges.
Code or symptom, part, service call
Lo on a JennAir freestanding range's display after you start the oven is a status, not an error: it says the oven is below 170 degrees F. Give it time to warm; the reading becomes a number as the oven heats.
JennAir says not to judge oven temperature with a thermometer, because the elements cycle and most thermometers react too slowly. Check preheat time, racks, pan spacing and foil first, then run the biscuit test before any calibration.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.