What it means
PRESS CLEAN BUTTON is the prompt that starts frother cleaning. Put a container under the milk spout and hold CLEAN on the milk container lid for at least 8 seconds; do not release until the progress bar finishes.
JennAir coffee machine PRESS CLEAN BUTTON / Milk system
PRESS CLEAN BUTTON is the prompt that starts frother cleaning. Put a container under the milk spout and hold CLEAN on the milk container lid for at least 8 seconds; do not release until the progress bar finishes.
Also shown as PRESS CLEAN BUTTON
PRESS CLEAN BUTTON is the prompt that starts frother cleaning. Put a container under the milk spout and hold CLEAN on the milk container lid for at least 8 seconds; do not release until the progress bar finishes.
The cleaning cycle runs liquid through the spout.
The progress bar never starts when you hold CLEAN.
Checks you have ticked / saved in this browser

The cleaning cycle runs liquid through the spout.

The button is on the milk container lid. CLEANING and a progress bar then appear.

The cycle stops if you release early.
Push the spout down against the container. Do not leave milk out for more than 15 minutes.
Send the model and the checks you have already run, then begin your request from this page.
Book a visit



A simplified drawing, because layouts change with the model. Tap an outlined part to see a photo and the related check.
It is the display prompt on the milk frother cleaning procedure.
Read the supporting manualSet a container under the spout, hold CLEAN on the lid for at least 8 seconds, and keep holding until the progress bar completes.
Read the supporting manualRemove the milk container, push the spout down against it and put it in the refrigerator.
Read the supporting manualIf CLEAN has no effect after a full hold, the button or its sensing may be the cause, and JennAir names no part.
Read the supporting manualManufacturer document
JennAir Product Help (producthelp.jennair.com)
dateModified 2025-03-19; PH 2032 / PH 2032 (built-in coffee maker, milk frother)
Scope: JennAir built-in coffee maker. Read from the JennAir Product Help message page for this code and checked against the overview page of display messages (November 2026).
No. It is the prompt shown when the frother cleaning cycle is ready to start.
At least 8 seconds, and then continue holding until the progress bar completes and cleaning has ended.
JennAir says the clean cycle stops when the button is released.
It is on the milk container lid, per the cleaning page and its picture.
Code or symptom, part, service call
INSERT MILK CONTAINER! means the milk container is missing or incorrectly positioned. Insert it correctly, pushing it in as far as it will go.
A display prompt halts brewing until you fix the condition: refill and seat the tank for FILL TANK, empty the grounds container, reseat the brewing unit, close the service door, or adjust a too-fine grind. DESCALE needs the descaling cycle. GENERAL ALARM means clean the inside.
Schedule a diagnostic for your model, carried out at the appliance.
Office details, plus the access notes to pass along.